Cutting Speed and Feed Influence on Surface Microhardness of Dry-Turned UNS A97075-T6 Alloy
Open Access
- 5 February 2020
- journal article
- conference paper
- Published by MDPI AG in Applied Sciences
- Vol. 10 (3) , 1049
Abstract
In this work, an analysis of the cutting speed and feed influence on surface roughness and microhardness of UNS A97075-T6 alloy, turned under dry conditions, was carried out. The results were compared before and after a corrosion process. The influence of these cutting parameters on each of these variables was analyzed, as well as the possible interrelation between them. The microgeometrical deviations showed a general trend to increase with feed. However, no significant modifications were observed as a function of the cutting speed. This trend was softer after the corrosion process, due to the surface alterations produced by pitting corrosion, which resulted in higher dispersion of the experimental data. In addition, a surface microhardness increment was observed in all samples, after machining and before corrosion, regardless of the cutting parameter values. The experimental results revealed that the mechanical effects, produced by the feed, should not be neglected against the thermal effects, produced by the cutting speed, within the range of the tested cutting speed. Finally, the corrosion process negatively affected the microhardness, but it was not possible to establish a direct relationship between the cutting parameters, surface roughness, and microhardness after a corrosion process.Keywords
This publication has 45 references indexed in Scilit:
- Investigation on corrosion fatigue crack growth rate in 7075 aluminum alloyMaterials & Design (1980-2015), 2013
- Finite element modeling of microstructural changes in turning of AA7075-T651 AlloyJournal of Manufacturing Processes, 2013
- Effect of Turning Parameters on Roundness and Hardness of Stainless Steel: SUS 303AASRI Procedia, 2012
- Preliminary Study of the Influence of Machining Conditions in the Response to Corrosion of UNS-A92024 AlloyAdvanced Materials Research, 2010
- Fabrication of Al7075/Al, two phase material, by recycling Al7075 alloy chips using powder metallurgy routeJournal of Alloys and Compounds, 2009
- Modelling the influence of machined surface roughness on the fatigue life of aluminium alloyInternational Journal of Fatigue, 2008
- Microstructural characterization of Al-7075-T651 chips and work pieces produced by high-speed machiningMaterials Science and Engineering: A, 2006
- Surface roughness of AA7050 alloy turned barsJournal of Materials Processing Technology, 2005
- The effect on fatigue life of residual stress and surface hardness resulting from different cutting conditions of 0.45%C steelInternational Journal of Machine Tools and Manufacture, 2005
- Surface Integrity Generated by Precision Hard TurningCIRP Annals, 1999