Design and Control of a Midair-Reconfigurable Quadcopter Using Unactuated Hinges
- 25 August 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Robotics
- Vol. 39 (1) , 539-557
Abstract
In this article, a novel quadcopter capable of changing shape midflight is presented, allowing for operation in four configurations with the capability of sustained hover in three. This is accomplished without requiring actuators beyond the four motors typical of a quadcopter. Morphing is achieved through freely rotating hinges that allow the vehicle arms to fold downwards by either reducing or reversing thrust forces. Constraints placed on the control inputs of the vehicle prevent the arms from folding or unfolding unexpectedly. This allows for the use of existing quadcopter controllers and trajectory generation algorithms with only minimal added complexity. For our experimental vehicle at hover, we find that these constraints result in a 36% reduction of the maximum yaw torque the vehicle can produce, but do not result in a reduction of the maximum thrust or roll and pitch torques. Experimental results show that, for a typical maneuver, the added limits have a negligible effect on the trajectory tracking performance. Finally, the ability to change configurations is shown to enable the vehicle to traverse small passages, perch on hanging wires, and perform limited grasping tasks.Keywords
All Related Versions
Funding Information
- National Science Foundation Graduate Research Fellowship (DGE 1752814)
- Berkeley Fellowship for Graduate Study
This publication has 35 references indexed in Scilit:
- Dynamic modeling of a multi-rotorcraft UAS with morphing capabilities2015
- Foldable and self-deployable pocket sized quadrotor2015
- Autonomous perching and take-off on vertical walls for a quadrotor micro air vehicle2015
- Minding the gap: in-flight body awareness in birdsFrontiers in Zoology, 2014
- Emergency landing for a quadrotor in case of a propeller failure: A backstepping approach2014
- Towards valve turning using a dual-arm aerial manipulator2014
- High-performance trajectory tracking control of a quadrotor with disturbance observerSensors and Actuators A: Physical, 2014
- Avian-Inspired Grasping for Quadrotor Micro UAVs2013
- Stability control in aerial manipulation2013
- Construction with quadrotor teamsAutonomous Robots, 2012