Investigation of precession laser machining of microholes in aerospace material
Open Access
- 1 February 2023
- journal article
- research article
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 35 (1) , 012028
Abstract
Sidewall tapering is one of the main limitations in ultrashort pulse (USP) laser machining and is associated with the beam shape and self-limiting effect. Laser processing with a precession beam is a potential solution to overcome this limitation. A study into the effects of precession parameters on the taper angle in microhole drilling of a nickel alloy is reported in this paper. The effects of three key precession parameters, i.e., incident angle, relative distance between the focuses of the precession and individual beams, and scanning speed, have been investigated in detail. Experiments were performed to drill through holes with aspect ratios up to 20:1 and diameters ranging from 100 to 500 μm over 0.6–2 mm thick nickel alloy substrates. Experiment results showed that all the considered parameters/factors were significant and affected the hole tapering in different ways. In addition, there were important interaction effects between two of the factors, i.e., incident angle and focus position, in some cases. The optimal parameters to minimize the tapering effect are suggested, and the mechanism is discussed in detail. The precession laser machining showed clear advantages in overcoming the limitations to associated with conventional USP laser machining. Fabricating microholes with high geometrical accuracy, i.e., with straight side walls and zero taper angles, is feasible with the use of a precession beam. The results clearly show the potential of precession laser processing and the capabilities that the technology can offer for a range of laser micromachining applications in different industries, such as microelectronics, automotive, and aerospace.Keywords
Funding Information
- UKRI Future Leaders Fellowship (MR/V02180X/1)
- European Structural Investment Funds
This publication has 28 references indexed in Scilit:
- Selecting significant effects in factorial designs: Lenth's method versus using negligible interactionsCommunications in Statistics - Simulation and Computation, 2017
- Understanding the self-limiting effect in picosecond laser single and multiple parallel pass drilling/machining of CFRP composite and mild steelMaterials & Design, 2016
- Taper Angle Correction in Cutting of Complex Micro-mechanical Contours with Ultra-Short Pulse LaserJournal of Mechanics Engineering and Automation, 2016
- Laser processing of medical devices2015
- Effect of geometry measurements on characteristics of femtosecond laser ablation of HR4 nickel alloyOptics and Lasers in Engineering, 2015
- An investigation on microstructures and mechanical properties of explosive cladded C103 niobium alloy over C263 nimonic alloyJournal of Materials Processing Technology, 2014
- Laser processing by using fluidic laser beam shaperInternational Journal of Heat and Mass Transfer, 2013
- Femtosecond laser ablation characteristics of nickel-based superalloy C263Applied Physics A, 2008
- Laser milling: Pulse duration effects on surface integrityProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2008
- Laser drilling of high aspect ratio holes in copper with femtosecond, picosecond and nanosecond pulsesApplied Physics A, 2007