Reactions of Ammonia and Urea Hydrolysis Products with Soil
Authors:
- 1 November 1988
- journal article
- research article
- Published by Wiley in Soil Science Society of America Journal
- Vol. 52 (6) , 1793-1796
Abstract
A quantitative description of pH changes in N fertilizer application zones is needed to predict the degree of NH 3 formation in the soil solution. In particular, the pH changes following surface application of urea determine in part the degree of NH 3 formation and possible loss by volatilization. The objectives of our study were to compare the rise in soil pH following addition of urea and NH 4 OH to soil, and evaluate the importance of inorganic C reactions to any differences in the rise in pH caused by the two respective N sources. Titration curves with urea or NH 4 OH as a base were used to determine differences in the patterns of pH change. Up to pH 8.2, soil pH was raised identically by NH 4 OH and urea that had been completely hydrolyzed. Above pH 8.2, urea was less effective than NH 4 OH in raising soil pH. The lower effectiveness of urea was due in part to the urea‐C not forming CO 2 but remaining as HCO − 3 and CO 2− 3 in the soil solution. Part of the CO 2− 3 precipitated as CaCO 3 when enough urea was added to raise soil pH to 8.8. At a lower application rate of urea, which resulted in a soil pH of 7.15, no CaCO 3 was detected. These results demonstrate the importance of inorganic C from urea hydrolysis in providing resistance to a pH increase above pH 8.2 in concentrated fertilizer application zones.Keywords
Funding Information
- Nat. Fertilizer Development Ctr. of Tennessee Valley Authority
This publication has 2 references indexed in Scilit:
- Titratable Acidity to Estimate Ammonia RetentionSoil Science Society of America Journal, 1987
- Ammonia Losses from Surface‐Applied Nitrogen Fertilizer as Controlled by Soluble Calcium and Magnesium: General TheorySoil Science Society of America Journal, 1981