Influence of Inclusions on the Nucleation of Acicular Ferrites in a Ti–Zr‐Bearing Steel
- 25 September 2021
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 93 (2)
Abstract
Laboratory experiments are conducted to study the influence of inclusions on the nucleation of acicular ferrite in Ti–Zr‐bearing steels. The ferrite transformation in steels with different Ti–Zr contents is observed using a high‐temperature confocal laser scanning microscope (HT‐CLSM). The average composition and size of inclusions and the information about the nucleation of acicular ferrite (AF) are analyzed using a scanning electron microscope. When the content of titanium in the steel increased from 70 to 370 ppm, the main composition in the inclusion transformed from Al2O3 to Ti2O3, the volume fraction of AF increased from 24.4% to 52.5%. The average content of ZrO2 in inclusions is 0%, 18.51%, and 90.39%, when the Zr content of steel is 0 80, and 140 ppm, the volume fraction of AF is 52.5%, 76.9%, and 56.8%. The relationship between the cosine of the contact angle at the inclusions‐ferrite interface and the diameter of inclusions is established based on experimental results, which is consistent with the results calculated based on the classic nucleation theory.Keywords
This publication has 37 references indexed in Scilit:
- In situ observation of the formation of intragranular acicular ferrite at non-metallic inclusions in C–Mn steelActa Materialia, 2010
- New insights into intragranular ferrite in a low-carbon low-alloy steelActa Materialia, 2009
- Effect of Zr addition to Ti-killed steel on inclusion formation and microstructural evolution in welding induced coarse-grained heat affected zoneActa Metallurgica Sinica (English Letters), 2008
- Effect of zirconium addition on the impact toughness of the heat affected zone in a high strength low alloy pipeline steelMaterials Characterization, 2008
- Characteristics of Fine Oxide Particles Produced by Ti/M (M=Mg and Zr) Complex Deoxidation in Fe–10mass%Ni AlloyISIJ International, 2008
- Nucleation of intragranular ferrite at Ti2O3 particle in low carbon steelActa Materialia, 1999
- Zr-containing precipitates in a TiNb microalloyed HSLA steel containing 0.016 wt.% Zr additionMaterials Science and Engineering: A, 1996
- The Role of Mn Depletion in Intra-Granular Ferrite Transformation in the Heat Affected Zone of Welded Joints with Large Heat Input in Structural Steels.ISIJ International, 1996
- Improvement in HAZ Toughness of Steel by TiN-MnS Addition.ISIJ International, 1994
- Effects of chemistry, density and size distribution of inclusions on the nucleation of acicular ferrite of CMn steel shielded-metal-arc-welding weldmentsMaterials Science and Engineering: A, 1992