Influence of external and internal length scale on the flow stress of copper
- 1 November 2007
- journal article
- Published by Walter de Gruyter GmbH in International Journal of Materials Research
- Vol. 98 (11) , 1047-1053
Abstract
The flow stress of bulk specimens is known to depend on the microstructure. With a reduction of specimen dimensions into the micrometer and nanometer regime, specimen size-effects also influence the mechanical properties. We characterized the size-dependent flow stress of copper over more than three orders of magnitude, starting from several tens of micrometers down to a few tens of nanometers. For this purpose nanoindentation, micro-compression, and tensile testing experiments were performed. Additionally, different grain sizes were generated by severe plastic deformation. The observed increase in flow stress with reduced critical dimension is discussed with respect to the different stress states and microstructures present in the reported experiments. The mechanism controlling deformation changes from dislocation pile-up for critical dimensions > 1 μm via a transition regime (1 μm > critical dimensions > 100 nm) to dislocation nucleation for critical dimensions < 100 nm.Keywords
This publication has 27 references indexed in Scilit:
- Corrigendum to “Comparison of incipient plasticity in bcc and fcc metals studied using nanoindentation” [Mater. Sci. Eng. A 426 (2006) 208–213]Materials Science and Engineering: A, 2006
- Grain-size dependence of the flow stress of Cu from millimeters to nanometersMetallurgical and Materials Transactions A, 2004
- Grain size dependence of the plastic deformation kinetics in CuMaterials Science and Engineering: A, 2003
- The correlation of the indentation size effect measured with indenters of various shapesJournal of the Mechanics and Physics of Solids, 2002
- Computational modeling of the forward and reverse problems in instrumented sharp indentationActa Materialia, 2001
- Determination of elastoplastic properties by instrumented sharp indentationScripta Materialia, 1999
- Size effects in materials due to microstructural and dimensional constraints: a comparative reviewActa Materialia, 1998
- Indentation size effects in crystalline materials: A law for strain gradient plasticityJournal of the Mechanics and Physics of Solids, 1998
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- The Deformation and Ageing of Mild Steel: III Discussion of ResultsProceedings of the Physical Society. Section B, 1951