Effects of Forming Conditions on Warm Incremental Press Formability of Ti-6Al-4V Alloy Sheets
- 1 January 2022
- journal article
- research article
- Published by The Japan Society for Technology and Plasticity in Journal of the Japan Society for Technology of Plasticity
- Vol. 63 (737) , 73-78
Abstract
In general, Ti-6Al-4V alloy sheets are formed by press forming in the temperature range of 600 and 900 ℃, which improves ductility. Because of the low ductility of Ti-6Al-4V alloy at temperatures between room temperature and 600 ℃, fracture easily occurs during press forming. Hence, to achieve press forming at 300 ℃, a method of press forming of Ti-6Al-4V alloy sheets at warm forming was developed. In this method, the punch motion and blank holding force were applied separately and incrementally to prevent fracture at the punch radius. In addition, the effects of forming conditions such as lubrication condition and punch motion on warm incremental press forming were investigated to achieve warm press forming without lubrication. As a result, by controlling the punch motion and punch speed in warm incremental press forming, we were able to obtain a formed cup without lubrication, the same as by forming with lubrication. By comparing the results at 300 and 500 ℃, we clarified that the formability was not affected by the forming temperature in warm incremental press forming.Keywords
This publication has 13 references indexed in Scilit:
- Forming limit diagram with anisotropy considering of Ti-6Al-4V sheets and prediction of ductile fracture by experiment and FEAProcedia Manufacturing, 2018
- Deformation characteristics of Ti-6Al-4V plate in mandrel-free hot spinningProcedia Manufacturing, 2018
- Forming of high strength titanium sheet at room temperatureMaterials & Design (1980-2015), 2015
- Failure and formability studies in warm deep drawing of Ti–6Al–4V alloyMaterials & Design (1980-2015), 2014
- Development of Hot Stamping Process for Aircraft Titanium Alloy Parts Using Resistance HeatingJournal of the Japan Society for Technology of Plasticity, 2014
- Formability of Ti–6Al–4V titanium alloy sheet in magnetic pulse bulgingMaterials & Design (1980-2015), 2013
- Tool development based on modelling and simulation of hot sheet metal forming of Ti–6Al–4V titanium alloyJournal of Materials Processing Technology, 2011
- Development of Incremental Forming Process withLocalized Heating for Titanium Alloy SheetJournal of the Japan Society for Technology of Plasticity, 2011
- Spin-forming Project Report2009
- Continuous electric resistance heating—Hot forming system for high-alloy metals with poor workabilityJournal of Materials Processing Technology, 2009