Shock wave compression of the ferroelectric ceramic Pb0.99(Zr0.95Ti0.05)0.98Nb0.02O3: Microstructural effects
Author:
- 1 March 2007
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 101 (5) , 053525
Abstract
Shock wave compression of poled results in rapid depoling and release of bound charge. Different porous microstructures can be produced in the material by adding different types and amounts of organic pore formers prior to bisque firing and sintering. In previous studies, extensive planar-impact experiments on a baseline material having a fixed porous microstructure were conducted to determine Hugoniot states, to examine constitutive mechanical properties during shock propagation, and to investigate shock-induced depoling characteristics. Additional comparative experiments were conducted to investigate the effects of a different porous microstructure in a material having the same density, and also the effects of different initial densities. These comparisons indicated that differences in the porous microstructure of common-density materials have little effect on mechanical and electrical shock properties, in contrast to large effects observed when initial density is varied. To examine microstructural effects more extensively in the present study, additional common-density materials having distinctly different microstructures were prepared. Each material was made using spherical pore formers having diameters within a narrow range, with the mean diameter varying over a broad range between the different materials. Normally poled samples of each material were subjected to two particular experimental conditions that had proved useful for revealing important depoling and yielding properties in the baseline material. Results from materials made with larger pore formers again indicated that shock properties are insensitive to microstructural differences in common-density materials. Materials made with the smallest pore formers were an important exception, with the most noticeable difference being a significantly higher threshold for dynamic yielding.
Keywords
This publication has 11 references indexed in Scilit:
- Shock wave compression of the ferroelectric ceramic Pb0.99(Zr0.95Ti0.05)0.98Nb0.02O3: Depoling currentsJournal of Applied Physics, 2004
- Shock wave compression of the ferroelectric ceramic Pb0.99(Zr0.95Ti0.05)0.98Nb0.02O3: Hugoniot states and constitutive mechanical propertiesJournal of Applied Physics, 2003
- Refractive index of sapphire at 532 nm under shock compression and releaseJournal of Applied Physics, 2002
- Shock-Recovery Experiments on PZT 95/51986
- Uniaxial-stress effects in a 95/5 lead zirconate titanate ceramicJournal of Applied Physics, 1978
- Pressure-temperature phase diagrams for several modified lead zirconate ceramicsJournal of Physics and Chemistry of Solids, 1978
- Laser interferometer for measuring high velocities of any reflecting surfaceJournal of Applied Physics, 1972
- Shock-wave compression of sapphire from 15 to 420 kbar. The effects of large anisotropic compressionsJournal of Physics and Chemistry of Solids, 1971
- Shock-Wave Studies of PMMA, Fused Silica, and SapphireJournal of Applied Physics, 1970
- Shock-Wave Compression of Barium Titanate and 95/5 Lead Zirconate TitanateJournal of Applied Physics, 1968