Computational Fluid Dynamics Study on Attainable Flow Rate in a Lamella Settler by Increasing Inclined Plates
Open Access
- 1 January 2019
- journal article
- Published by Japan Society on Water Environment in Journal of Water and Environment Technology
- Vol. 17 (2) , 76-88
Abstract
In the construction or renovation of settling tanks for water treatment systems, installing lamella baffles is a promising alternative to reduce the footprint. Conventionally, the increasing flow rate in a lamella settling tank is calculated based on the contribution of the entire projected area of inclined plates to lamella settler capacity. However, this design criterion is not fully verified. In this study, computational fluid dynamics (CFD) was used to simulate the sedimentation tank and lamella settling tank under different flow rates. Simulation results indicated that, at the targeted suspended solids (SS) removal efficiency of 82%, which corresponded to the original linear velocity of 1 m3/(m2·h), a 1.5-fold increase in flow rate required no less than a 6.2-fold increase in settling area using inclined plates. The actual effectiveness of baffles (α) on increased flow rate was estimated to be a maximum of 7.9%. Inclined plates had different influences on the SS removal efficiency of each particle group. Further, the baffle configuration was proven to influence the flow pattern and therefore the performance of the tanks. Using CFD, the SS removal efficiency in settling tanks and lamella setting tanks could be predicted accurately and their design could be significantly optimized.Keywords
This publication has 11 references indexed in Scilit:
- The influence of lamellar settler in sedimentation tanks for potable water treatment — A computational fluid dynamic studyPowder Technology, 2014
- Tracer experiment and RTD analysis of DAF separator with bar-type bafflesWater Science & Technology, 2013
- A Computational Fluid Dynamics Model of Flow and Settling in Sedimentation Tanks2012
- Critical modeling parameters identified for 3D CFD modeling of rectangular final settling tanks for New York City wastewater treatment plantsWater Science & Technology, 2012
- Experimental investigation of effects of baffle configurations on the performance of a secondary sedimentation tankScientia Iranica, 2011
- Development of a flocculation sub-model for a 3-D CFD model based on rectangular settling tanksWater Science & Technology, 2011
- A CFD methodology for the design of sedimentation tanks in potable water treatmentChemical Engineering Journal, 2008
- Verification and application of a mathematical model for the assessment of the effect of guiding walls on the hydraulic efficiency of chlorination tanksJournal of Hydroinformatics, 2002
- Numerical modeling of flow and settling in primary rectangular clarifiersJournal of Hydraulic Research, 1989
- Lamella and tube settlers. 2. Flow stabilityIndustrial & Engineering Chemistry Process Design and Development, 1983