Fabrication of an antifouling PES ultrafiltration membrane via blending SPSF
Authors:
Open Access
- 5 January 2022
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 12 (3) , 1460-1470
Abstract
Sulfonated polysulfone (SPSF) with different sulfonation degrees (10%, 30%, and 50%) was added to polyethersulfone (PES) to improve the separation and antifouling performance of polyethersulfone ultrafiltration membranes. The PES/SPSF blend ultrafiltration membrane was prepared by the non-solvent induced phase inversion method (NIPS), and the effect of sulfonation degree on the ultrafiltration performance was studied. The compatibility of SPSF and PES was calculated by the group contribution method, and confirmed by differential scanning calorimetry (DSC). The morphology and surface roughness of the membrane were characterized by scanning electron microscopy (SEM) and atomic force microscopy (AFM), the chemical composition of the membrane was analyzed by X-ray photoelectron spectroscopy (XPS) and infrared spectroscopy (FTIR), and the permeability and anti-fouling performance of the blend membrane were studied through filtration experiments. The research shows that the flux and anti-fouling performance of the blend membrane have been improved after adding SPSF. When the sulfonation degree of the SPSF is 30%, the pure water flux of the blend membrane can reach 530 L m−2 h−1, the rejection rate of humic acid (HA) is 93%, the flux recovery rate of HA increases from 69.23% to 79.17%, and the flux recovery rate of BSA increases from 72.56% to 83%.Keywords
This publication has 35 references indexed in Scilit:
- The effect of polymer concentration and additives of cast solution on performance of polyethersulfone/sulfonated polysulfone blend nanofiltration membranesDesalination and Water Treatment, 2014
- Recent advances in preparation and morphology control of polymeric membranes formed by nonsolvent induced phase separationCurrent Opinion in Chemical Engineering, 2013
- Preparation and Performance of Antifouling PVC/CPVC Blend Ultrafiltration MembranesIndustrial & Engineering Chemistry Research, 2012
- Preparation and Characterization of PES/SPSF Blend Ultrafiltration MembraneAdvanced Materials Research, 2011
- Highly hydrophilic and low-protein-fouling polypropylene membrane prepared by surface modification with sulfobetaine-based zwitterionic polymer through a combined surface polymerization methodJournal of Membrane Science, 2010
- Pluronic polymers and polyethersulfone blend membranes with improved fouling-resistant ability and ultrafiltration performanceJournal of Membrane Science, 2006
- Development of an ultrasonic technique for in situ investigating the properties of deposited protein during crossflow ultrafiltrationJournal of Colloid and Interface Science, 2005
- Nonsolvent-Induced Gelation and Its Effect on Membrane MorphologyMacromolecules, 2002
- Polysulfone — sulfonated poly(ether ether) ketone blend membranes: systematic synthesis and characterisationJournal of Membrane Science, 2001
- Miscibility Behavior of Polybenzimidazole/Sulfonated Polysulfone Blends for Use in Fuel Cell ApplicationsMacromolecules, 2000