Research on the Possibilities of Reusing Mixed Reclaimed Asphalt Materials with a Focus on the Circular Economy
Open Access
- 12 November 2025
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 15 (22) , 12004
Abstract
This article presents the results of a 10-year research study on the possibilities of implementing circular economy principles into the recovery of construction waste in road construction and paving traffic areas. According to Eurostat, construction waste accounts for approximately 25–30% of the total amount of waste produced in Europe. New legislative policies strongly support selective demolition and recycling with the aim of recycling at least 70% of construction waste. The subject of this research was mixed reclaimed asphalt material (MRAM) composed of 70% asphalt mixture, 10% aggregate, 10% concrete, and 10% soil. Isomorphic models and experimental sections made of MRAM showed that the required characteristics cannot be achieved when using MRAM without heating and compaction. When laying MRAM using a light dynamic plate and additional heating due to solar radiation, the LDD 100 device detected a 53% increase in the deformation modulus. On isomorphic MRAM models, the CBR test showed a 4-, 5-, and 14-times increase in the CBR value when the temperature was increased from 20 °C to 40, 50, and 70 °C. The laboratory results were confirmed by monitoring the surface condition of a local road rehabilitated between 2017 and 2025 using MRAM, where some sections showed the properties of semi-bound layers after eight years. The road surface was improved with a 20 cm layer of MRAM at an air temperature of 30 °C and compacted with a 10-ton smooth roller. The research results presented made it possible to create a proposal for a systematic approach to the evaluation of materials obtained from asphalt roads, optimized on the principles of the circular economy.Keywords
This publication has 50 references indexed in Scilit:
- A review study on utilization of waste cooking oil, eggshell, glass, and plastic in bituminous mixturesEnvironmental Science and Pollution Research, 2025
- Research on macro and micro performance degradation of hot in-place recycled asphalt mixtures with high RAP contentsCase Studies in Construction Materials, 2025
- 2024, A Landmark Year for Climate Change and Global Carbon Capture, Utilization, and Storage: Annual Progress ReviewEnergy Science & Engineering, 2025
- Design and performance assessment of sustainable road pothole patching materials using waste cooking oil, plastic, and reclaimed asphalt pavementConstruction and Building Materials, 2024
- Prediction of greenhouse gas emissions from municipal solid waste incinerators with consideration of utilization of heat and captured CO2 in the Tokyo waterfront areaJournal of Material Cycles and Waste Management, 2023
- Green synthesis of nanoparticles from biodegradable waste extracts and their applications: a critical reviewNanotechnology for Environmental Engineering, 2022
- Eco-friendly design of Warm mix asphalt (WMA) with recycled concrete aggregate (RCA): A case study from a developing countryConstruction and Building Materials, 2022
- The utilization of waste plastics in asphalt pavements: A reviewCleaner Materials, 2021
- Sustainable Practice in Pavement Engineering through Value-Added Collective Recycling of Waste Plastic and Waste Tyre RubberEngineering, 2021
- Sustainable development in a post-Brundtland worldEcological Economics, 2006