Investigation of the Enhancement of Heat Transfer in a Flat Plate Solar Collector With a Corrugated Tube Under Thermosiphon Effect
- 12 January 2024
- journal article
- research article
- Published by ASME International in Journal of Solar Energy Engineering
- Vol. 146 (4) , 1-26
Abstract
The development of new technologies for energy generation and use has been increasing significantly. In this projection, the use of flat solar collectors to convert solar energy into thermal energy through water heating for residential and commercial purposes has grown due to the potential reduction of up to 40% in electrical energy consumption promoted by these devices. A promising but underexplored area in engineering is the study of the intensification of heat transfer in these devices by changing the dimensional and constructive characteristics of the elevation tubes, especially through a numerical approach by passive systems that operate under the thermosiphon effect. Thus, this work aims to investigate, by using computational fluid dynamics (CFD), the heat transfer process in a flat plate solar collector with a concentric plate to the elevation tube, evaluating different diameters, angles of inclination, and slope corrugation profiles subjected to a constant heat flux. The numerical modeling considers a single-phase, incompressible, permanent, three-dimensional, and laminar flow, in addition to the Boussinesq approximation. The results showed that significant increases in the heat transfer rate can be achieved with absorber plates in comparison to those configurations without absorber plates. Moreover, the increase in the tube diameter allowed gains of up to 5.1% in the heat transfer rate, while the increase in the angle of inclination did not promote significant improvements. The triangular profile R10 P20 configuration increased the Nusselt number by 8%, while the R5 P20 configuration promoted a 25% gain in thermo-hydraulic performance.Keywords
This publication has 46 references indexed in Scilit:
- Natural convection between a circular enclosure and an elliptic cylinder using Control Volume based Finite Element MethodInternational Communications in Heat and Mass Transfer, 2012
- The influence of artificial roughness shape on heat transfer enhancement: Corrugated tubes, dimpled tubes and wire coilsApplied Thermal Engineering, 2012
- Experimental studies on heat transfer and thermal performance characteristics of thermosyphon solar water heating system with helical and Left–Right twisted tapesEnergy Conversion and Management, 2011
- Studies on heat transfer and friction factor characteristics of thermosyphon solar water heating system with helical twisted tapesEnergy, 2009
- The Sun’s apparent position and the optimal tilt angle of a solar collector in the northern hemisphereSolar Energy, 2009
- Procedure for Estimation and Reporting of Uncertainty Due to Discretization in CFD ApplicationsJournal of Fluids Engineering, 2008
- Experimental investigation on heat transfer and frictional characteristics of spirally corrugated tubes in turbulent flow at different Prandtl numbersInternational Journal of Heat and Mass Transfer, 2004
- Convective heat transfer to temperature dependent property fluids in the entry region of corrugated tubesInternational Journal of Heat and Mass Transfer, 2002
- The natural circulation solar water heater model with linear temperature distributionRenewable Energy, 2002
- System design in solar water heaters with natural circulationSolar Energy, 1968