Microstructure and compressive properties of chill-cast Mg–Al–Ca alloys
Authors:
- 1 March 2006
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 21 (3) , 613-622
Abstract
Mg82Al8Ca10 was determined to be a pseudo-binary eutectic composition [liquid solidifying into α–Mg and (Mg,Al)2Ca in the Mg–Al–Ca ternary system with a eutectic melting temperature of 789 K]. A series of Mgx(Al0.44Ca0.56)100−x alloys, where 75 ≤ x ≤ 95, were cast into Φ4 mm rods using copper mold casting. The eutectic alloy exhibits the highest fracture strength, σf = 609 MPa. For 75 ≤ x ≥ 79, the alloys have hypereutectic microstructures with Mg2Ca as the primary phase, and σf is reduced together with diminishing plasticity. For hypoeutectic alloys with 86 ≤ x ≥ 95, the volume fraction of the primary α–Mg dendrites dispersed in the eutectic matrix increases with increasing x, resulting in a gradual decrease of the yield and fracture strengths but improved plastic strain to as large as 9%. The refined microstructures created in bulk samples via chill casting can lead to a good combination of strength and plasticity, with specific strength superior to commercial Mg alloys.Keywords
This publication has 31 references indexed in Scilit:
- Mg-based bulk metallic glass composites with plasticity and gigapascal strengthActa Materialia, 2005
- In situ formed Ti–Cu–Ni–Sn–Ta nanostructure-dendrite composite with large plasticityActa Materialia, 2003
- A new Mg65Cu7.5Ni7.5Zn5Ag5Y10 bulk metallic glass with strong glass-forming abilityJournal of Materials Research, 2003
- Fabrication of ternary Mg–Cu–Gd bulk metallic glass with high glass-forming ability under air atmosphereJournal of Materials Research, 2003
- Bulk metallic glass formation in the Mg–Cu–Zn–Y systemScripta Materialia, 2002
- Mechanical properties of Zr56.2Ti13.8Nb5.0Cu6.9Ni5.6Be12.5 ductile phase reinforced bulk metallic glass compositeActa Materialia, 2001
- Fabrication of Bulk Mg–Cu–Ag–Y Glassy Alloy by Squeeze CastingMaterials Transactions, JIM, 2000
- Thermal Stability and Mechanical Properties of Mg–Y–Cu–M (M = Ag, Pd) Bulk Amorphous AlloysMaterials Transactions, JIM, 2000
- Structure and mechanical properties of two Mg–Al–Ca alloys consolidated from atomised powderMaterials Science and Technology, 1999
- Mg–Cu–Y Amorphous Alloys with High Mechanical Strengths Produced by a Metallic Mold Casting MethodMaterials Transactions, JIM, 1991