Online pressure–volume–temperature measurements of polypropylene using a testing mold to simulate the injection‐molding process
- 28 June 2010
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 118 (1) , 200-208
Abstract
To obtain accurate prediction of service performance and service life of polymers and to optimize the processing parameters, a modified online measurement was used to measure the pressure–volume–temperature (PVT) properties of polymers under certain processing conditions. The measurement was based on an injection molding machine, and it was used to obtain the PVT data of polymers directly with a special testing mold under normal processing conditions. The PVT properties of a semicrystalline polymer, polypropylene, were measured through both an online testing mold and a conventional piston–die dilatometer. The PVT properties were correlated by a modified two‐domain Tait equation of state. The differences between the two groups of PVT data measured were investigated, and relative differences, especially in the rubbery state because of different cooling or heating measuring modes and sample forms, were observed. Numerical simulations of injection‐molding processes were carried out by Moldflow software with both of the types of PVT data. The resulting online PVT data exhibited improvement in the accurate prediction of shrinkage and warpage. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010Keywords
This publication has 19 references indexed in Scilit:
- Anisotropic shrinkage of injection molded poly vinylidene fluoride samplesPolymer Engineering & Science, 2007
- Injection molding shrinkage of PP: Experimental progressPolymer Engineering & Science, 2006
- On‐line measurement of the PVT properties of polymer melts using a gear pumpAdvances in Polymer Technology, 2004
- Influence of cooling rate on pVT‐data of semicrystalline polymersJournal of Applied Polymer Science, 2001
- A method for measuring PVT relationships of thermoplastics using an injection molding machinePolymer Engineering & Science, 1995
- Experimental and theoretical studies of shrinkage, warpage, and sink marks of crystalline polymer injection molded partsPolymer Engineering & Science, 1995
- Crystallization of polypropylene, nylon‐66 and poly(ethylene terephthalate) at pressures to 200 MPa: Kinetics and characterization of productsJournal of Polymer Science Part B: Polymer Physics, 1994
- Morphological changes in isotactic polypropylene as a function of cooling rateJournal of Macromolecular Science, Part B, 1992
- The equation of state and heat of fusion of poly(ether ether ketone)Journal of Polymer Science Part B: Polymer Physics, 1989
- Pressure‐specific volume‐temperature behavior of thermoplastics under normal processing conditionsPolymer Engineering & Science, 1977