Strategy for designing accelerated aging tests to evaluate IGBT power modules lifetime in real operation mode
Authors:
- 4 August 2003
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components and Packaging Technologies
- Vol. 26 (2) , 429-438
Abstract
Accelerated aging tests are widely used in electronics industry to validate the technological choices of packaging, especially when significant lifetime is required. The thermal coefficient of expansion mismatch between the soldered materials results in crack propagation in the solder joints, which irreversibly increases the thermal resistance of the assembly and progressively leads to the failure of the module. Accelerated testing is very expensive and can last a long time, so that such experiments must be optimized. In addition, thermomechanical behavior of the assembly under realistic operating conditions for long times can be studied in shorter times thanks to finite element simulations. Non-linear finite element simulations have been carried out to make a correlation between accelerated aging tests and real operation. Stress-strain history under representative thermal loading has been determined in both cases. The energy dissipated in solder joints has been calculated and has been used as an estimator of the damage in the solder joint. Finally, thermal fatigue experiments with representative samples have allowed validating the previous results. This study is a step toward the understanding of the correlation between accelerated testing and actual operating conditions.Keywords
This publication has 15 references indexed in Scilit:
- Energy-based methodology for the fatigue-life prediction of solder materials2002
- Extensive fatigue investigation of solder joints in IGBT high power modules2002
- Evaluation of the creep of the Sn/sub 62/Pb/sub 36/Ag/sub 2/ solder alloy by the measurement of the stresses in a silicon dieIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part A, 1998
- Finite element simulation of the temperature cycling testsIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part A, 1997
- A Finite Element Study of Factors Affecting Fatigue Life of Solder JointsJournal of Electronic Packaging, 1994
- Energy based methodology for damage and life prediction of solder joints under thermal cyclingIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part B, 1994
- Thermal Cycling Induced Plastic Deformation in Solder Joints—Part I: Accumulated Deformation in Surface Mount JointsJournal of Electronic Packaging, 1991
- Low-Frequency, High-Temperature Low Cycle Fatigue of 60Sn-40Pb Solder1988
- Damage Accumulation and Fracture Life in High-Temperature Low-Cycle Fatigue1982
- Microplastic Strain Hysteresis Energy as a Criterion for Fatigue FractureJournal of Basic Engineering, 1961