Comparison of MgCl2and CdCl2 Activation Treatment for CDTE Solar Cells: Recrystallization and Defects
- 1 June 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1669-1673
Abstract
One of the key factors for the success of CdTe solar cells is the so-called “activation” treatment, consisting in depositing a CdCl 2 film on the CdTe layer and subsequent annealing it in air. Recent studies have found MgCl 2 as a good alternative. In this work we have studied devices (exceeding 14% efficiency) prepared by low-substrate temperature CdTe deposition and activated with MgCl 2 treatment (applied by wet deposition). The CdTe films recrystallized by MgCl 2 were analyzed in terms of X-ray diffraction, atomic force microscopy, photoluminescence measurement and compared with the standard CdCl 2 treated CdTe cells. Results show that different defects are detected for MgCl 2 treated sample. Moreover MgCl 2 treated cell does not need a post deposition treatment of the back contact to deliver high current density, showing that different electrical properties of the CdTe are registered.Keywords
This publication has 6 references indexed in Scilit:
- A Survey on Mismatching and Aging of PV Modules: The Closed LoopIEEE Transactions on Industrial Electronics, 2015
- A statistical analysis on the cell parameters responsible for power degradation of fielded pv modules in a hot-dry climate2014
- A Dynamic Photovoltaic Model Incorporating Capacitive and Reverse-Bias CharacteristicsIEEE Journal of Photovoltaics, 2013
- Sub-module differential power processing for photovoltaic applications2013
- Cell binning method analysis to minimize mismatch losses and performance variation in Si-based modules2003
- Partial shadowing of photovoltaic arrays with different system configurations: literature review and field test resultsSolar Energy, 2003