Numerical micromechanical investigation of interfacial strength parameters in a carbon fibre composite material
Authors:
- 22 February 2013
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 48 (6) , 749-760
Abstract
A finite element micromechanical model of a high strength composite material is subjected to a range of loading conditions to demonstrate its ability to predict failure. An investigation into the relative magnitude and distribution of the normal and shear stresses within the interface region of a single fibre embedded in a matrix region is compared to that of a multi-fibre representative volume element, where the fibre placement is statistically equivalent to that of a real material. A study is subsequently undertaken in which the relative magnitudes of the shear and normal strengths of the fibre–matrix interface are varied under transverse tension and shear. The results are interpreted with relation to the yield strength of the matrix. The predicted performance of the composite is shown to compare well with published experimental data, under transverse tension and in-plane shear. It is concluded that a single set of interface strength parameters can be used to represent the behaviour of the composite material. The results also show that interfacial shear strengths are expected to be equal, and higher than the interfacial normal strength.Keywords
This publication has 26 references indexed in Scilit:
- Micromechanical modelling of the transverse damage behaviour in fibre reinforced compositesComposites Science and Technology, 2011
- Identification of Damage and Plasticity Parameters for Continuum Damage Mechanics Modelling of Carbon and Glass Fibre‐Reinforced Composite MaterialsStrain, 2011
- A virtual experimental approach to estimate composite mechanical properties: Modeling with an explicit finite element methodComputational Materials Science, 2010
- Effect of fiber, matrix and interface properties on the in-plane shear deformation of carbon-fiber reinforced compositesComposites Science and Technology, 2010
- A cubic spline implementation of non-linear shear behaviour in three-dimensional progressive damage models for composite laminatesComposite Structures, 2010
- Prediction of the failure locus of C/PEEK composites under transverse compression and longitudinal shear through computational micromechanicsComposites Science and Technology, 2008
- Mechanical behavior of unidirectional fiber-reinforced polymers under transverse compression: Microscopic mechanisms and modelingComposites Science and Technology, 2007
- Three-dimensional stress analysis of bolted single-lap composite jointsComposite Structures, 1998
- Measurement of mixed-mode delamination fracture toughness of unidirectional glass/epoxy composites with mixed-mode bending apparatusComposites Science and Technology, 1996
- Combined effects of the fibre distribution and of the fibre matrix or interphase matrix transverse modulus ratio on the possible fracture modes of unidirectional composites submitted to a transverse loadingActa Metallurgica et Materialia, 1995