Influence of Temperature on the Pressure Distribution Within Press Pack IGBTs
Authors:
Top Cited Papers
- 6 September 2017
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 33 (7) , 6048-6059
Abstract
Press pack (PP) packaging technology has been applied to insulated-gate bipolar transistors (IGBTs) for high-voltage and high power density applications in recent years. The pressure distribution within PP IGBTs is very important because it affects both the electrical and thermal contact resistances, thermal cycling capability, and short-circuit current rating. Too much pressure will mechanically damage the chip and too little pressure will increase the thermal contact resistance, which eventually leads to chip thermal damage. In this paper, a finite-element multiphysics model cocoupled with an electrical field, thermal field, and mechanical field is proposed to analyze the collector current distribution, pressure distribution, and junction temperature distribution within PP IGBTs. The most important coupling variables, such as electrical and thermal contact resistances, for this cocoupled multiphysics model are calculated or measured by experiment through a single IGBT/fast-recovery diode chip submodule. Based on this multiphysics model, the influence of the high temperature generated by the chip's power dissipation on the pressure distribution within PP IGBTs (in the heating phase) is discussed, and then, compared with the pressure distribution in the clamping phase. The results show that the pressure distribution within PP IGBTs in the heating phase is extremely uneven and different from the value in the clamping phase. Furthermore, the mechanical model and its boundary conditions are verified through the pressure distribution experimental results in the clamping phase, which is measured based on the Fuji prescale film and the clamping test bench. Based on the simulation and experimental results, an optimization of the collector electrode and pedestal is proposed to improve the pressure distribution within PP IGBTs in the heating phase.Keywords
Funding Information
- National Natural Science Foundation of China (51477048)
- National Key R&D Program of China (2016YFB0901800)
This publication has 8 references indexed in Scilit:
- Optimization of the thermal contact resistance within press pack IGBTsMicroelectronics Reliability, 2017
- Dynamic thermal modelling and analysis of press-pack IGBTs both at component-level and chip-level2013
- Influence of the clamping pressure on the electrical, thermal and mechanical behaviour of press-pack IGBTsMicroelectronics Reliability, 2013
- Mechanical analysis of press-pack IGBTsMicroelectronics Reliability, 2012
- An overview of the reliability prediction related aspects of high power IGBTs in wind power applicationsMicroelectronics Reliability, 2011
- Thermo-mechanical finite element analysis in press-packed IGBT designMicroelectronics Reliability, 2000
- Power cycling on press-pack IGBTs: measurements and thermomechanical simulationMicroelectronics Reliability, 1999
- Thermo-mechanical simulation of a multichip press-packed IGBTSolid-State Electronics, 1998