Phase‐current waveform for switched reluctance motors to eliminate input‐current ripple and torque ripple in low‐power propulsion below magnetic saturation
Open Access
- 29 September 2020
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 13 (15) , 3351-3359
Abstract
In recent decades, switched reluctance motors (SRMs) have been attracting increasing attention as a promising type of traction motors for electric vehicle propulsion, owing to their robust construction, elimination of permanent magnets. However, their phase inductance profile contains significant high‐order harmonics, which generates input‐current and torque ripples under SRM drive with the conventional square phase‐current waveform. This study solves this problem by proposing a novel phase‐current waveform in replacement of this square waveform. The proposed waveform is a predetermined waveform that can be stored as a look‐up table in the inverter controller and can be magnified or attenuated to adjust the output torque, similarly as the conventional square waveform. Certainly, SRMs generally exhibit magnetic non‐linearity due to magnetic saturation, which complicates the analysis. Therefore, the proposed waveform is analytically derived under the assumption that the magnetisation of the motor remains below the saturation level because vehicle propulsion tends to require a torque output far smaller than the maximum rating of the motor in normal vehicle travel. The proposed phase‐current waveform is experimentally tested in comparison with the conventional square phase‐current waveform. Consequently, the proposed waveform revealed smaller ripples in both the input‐current and torque, supporting the effectiveness of the proposed phase‐current waveform.Keywords
This publication has 26 references indexed in Scilit:
- An Extended-Speed Low-Ripple Torque Control of Switched Reluctance Motor DrivesIEEE Transactions on Power Electronics, 2014
- Minimization of Torque Ripple and Copper Losses in Switched Reluctance DriveIEEE Transactions on Power Electronics, 2011
- Optimization and Evaluation of Torque-Sharing Functions for Torque Ripple Minimization in Switched Reluctance Motor DrivesIEEE Transactions on Power Electronics, 2009
- A Simple Nonlinear Logical Torque Sharing Function for Low-Torque Ripple SR DriveIEEE Transactions on Industrial Electronics, 2009
- A new torque and flux control method for switched reluctance motor drivesIEEE Transactions on Power Electronics, 2002
- Proposition of an offline learning current modulation for torque-ripple reduction in switched reluctance motors: design and experimental evaluationIEEE Transactions on Industrial Electronics, 2002
- Design and precise realization of optimized current waveforms for an 8/6 switched reluctance driveIEEE Transactions on Power Electronics, 2002
- Adaptive torque-ripple minimization in switched reluctance motorsIEEE Transactions on Industrial Electronics, 2001
- On torque ripple reduction in current-fed switched reluctance motorsIEEE Transactions on Industrial Electronics, 1999
- Torque ripple minimization in switched reluctance motor drives by PWM current controlIEEE Transactions on Power Electronics, 1996