Symmetrical Doherty Power Amplifier With Extended Bandwidth and Back-Off Range Based on Nonlinear Current Profile
- 5 November 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 72 (7) , 3204-3214
Abstract
There are lots of works on the bandwidth extension of symmetrical Doherty power amplifier (S-DPA) with a back-off range of 6 dB. However, it is still a challenge to simultaneously extend the bandwidth and back-off range of a S-DPA. This paper proposes a design methodology for extending the back-off range of a broadband S-DPA. Nonlinear current profile is introduced into the carrier sub-amplifier of the S-DPA. In this way, unequal power will be delivered to the load by the carrier and peaking amplifiers, leading to an extended high efficiency power range. More importantly, compared with previous works, the inversion ratio of the impedance inverter after the carrier transistor will be reduced in the proposed S-DPA, increasing the operation bandwidth. The combiner parameters of the proposed S-DPA with extended back-off range are derived based on a pre-determined nonlinear current profile. It is illustrated that the combiner parameters of the S-DPA can be expressed as a function of the combining load. Then, the bandwidth of the proposed S-DPA is subsequently analyzed under different combining load conditions. As a validation, a 1.4–2.2 GHz S-DPA with extended back-off range is implemented in this paper. Under a continuous-wave (CW) signal excitation, the fabricated S-DPA achieves a maximum output power of 40.2–43 dBm, a saturation drain efficiency (DE) of 56%–74% and a 9.0 dB back-off DE of 45%–52.5% over 1.4–2.2 GHz. Moreover, the fabricated S-DPA is also measured by the excitation of a 20 MHz modulated signal with a peak-to-average power ratio (PAPR) of 8.0 dB. The measured adjacent channel leakage ratios (ACLRs) of the fabricated S-DPA changes from $-$ 30.7 dBc to $-$ 21.1 dBc at the lower band and from $-$ 31.9 to $-$ 21.1 dBc at the upper band over 1.4–2.2 GHz when the average output power is 33.0 dBm.Keywords
Funding Information
- National Natural Science Foundation of China (62201100, 62171068, 62001061, 62171065)
- China Postdoctoral Science Foundation (2022M710506)
This publication has 37 references indexed in Scilit:
- Broadband Virtual-Stub Doherty Power Amplifier Using Asymmetric StructureIEEE Access, 2023
- Broadband High-Efficiency Dual-Mode Doherty Power Amplifier Using Hybrid F/F–1 Continuous-Mode TechnologyIEEE Transactions on Circuits and Systems I: Regular Papers, 2023
- Doherty’s Dominance Continued: A Linear PA Using GaN-on-SiIEEE Microwave Magazine, 2023
- A Millimeter-Wave Three-Way Doherty Power Amplifier for 5G NR OFDMIEEE Journal of Solid-State Circuits, 2023
- A Doherty Power Amplifier With Extended High-Efficiency Range Using Three-Port Harmonic Injection NetworkIEEE Transactions on Circuits and Systems I: Regular Papers, 2022
- Continuous-Mode Hybrid Asymmetrical Load- Modulated Balanced Amplifier With Three-Way Modulation and Multi-Band ReconfigurabilityIEEE Transactions on Circuits and Systems I: Regular Papers, 2021
- Bandwidth Extension of Three-Way Doherty Power Amplifier With Reactance Compensation Using Parallel Peaking AmplifiersIEEE Access, 2021
- Design of 74% Fractional Bandwidth Continuous-Mode Doherty Power Amplifier Using Compensation SusceptanceIEEE Transactions on Circuits and Systems II: Express Briefs, 2020
- Co-Design of Matching Sub-Networks to Realize Broadband Symmetrical Doherty With Configurable Back-Off RegionIEEE Transactions on Circuits and Systems II: Express Briefs, 2019
- Extending high‐efficiency power range of symmetrical Doherty power amplifiers by taking advantage of peaking stageIET Microwaves, Antennas & Propagation, 2017