The Development of Low-Current Surface Arcs Under Clean and Salt-Fog Conditions in Electricity Distribution Networks
Open Access
- 16 February 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 6, 15835-15843
Abstract
Electricity distribution networks are built to deliver increasing amount of electricity from distributed energy resources (DERs) such as offshore and onshore wind and solar farms. Aging of network assets through low-current surface discharges is becoming a great concern for the security and reliability of the distributed energy supply. In particular coastal conditions can present a challenge for overhead line insulators through the environment of salt fog. Also, onshore areas may expose power lines to clean fog and agricultural or industrial pollution. In this paper, experimental studies are conducted to investigate electrical arc formation and growth on insulators, following the testing standards in accordance with IEC 61109. Dry-band arcs in both clean-fog and salt-fog environments are compared. It is identified that arcs are much faster to develop and have greater energy in salt-fog environments, due to the lower surface resistance and resulting higher leakage current. The time from a first arc to strike, to the situation where the arc is stable on the insulator surface is identified as a potentially critical parameter in controlling aging of an insulation surface. The time from initial appearance of an arc to full stability is eight times shorter in a salt fog of 16,000 $\mu \text{S}$ /cm compared to a clean fog of $600~\mu \text{S}$ /cm. This means the very existence of a stable low-current arc is much more likely in polluted conditions. Accumulated arc energy and heat dissipation have been calculated for both fog conditions. It is concluded that aging by low-current electrical arcs tends to be more severe in salt-fog environments, so that great care needs to be taken when designing overhead lines and insulators in such areas.Keywords
This publication has 23 references indexed in Scilit:
- Self-consistent multi-arcs dynamic model for high voltage polluted insulatorsIEEE Transactions on Dielectrics and Electrical Insulation, 2016
- Semiconductive polymeric coatings for outdoor polymeric insulationIEEE Transactions on Dielectrics and Electrical Insulation, 2016
- Infrared analysis of dry-band flashover of silicone rubber insulatorsIEEE Transactions on Dielectrics and Electrical Insulation, 2016
- Assessment of the resistance to tracking of polymers in clean and salt fogs due to flashover arcs and partial discharges degrading conditions on one insulator modelIET Generation, Transmission & Distribution, 2016
- Leakage current analysis on RTV coated porcelain insulators during long term fog experimentsIEEE Transactions on Dielectrics and Electrical Insulation, 2014
- Effect of environment factors on ac flashover performance of 3 units of polluted insulator strings under natural fog conditionIEEE Transactions on Dielectrics and Electrical Insulation, 2014
- Performance of insulators treated with semiconductive silicone rubber coating during fog and polluted conditions2012
- Thermal models of short arc between high current contacts2002
- Study of creepage distance of the contaminated insulator in correlation with salt deposit density2002
- Artificial testing and evaluation of RTV coatings in a salt-fog chamberIEEE Transactions on Electrical Insulation, 1991