Vacuum brazing route for large-scale grid manufacturing in negative ion beam generation
Authors:
- Ravi PandeyRPRavi Pandey
- M.J. SinghMSM.J. Singh
- Jaydeep JoshiJJJaydeep Joshi
- Mainak BandyopadhyayMBMainak Bandyopadhyay
- Arun K ChakrabortyACArun K Chakraborty
- 6 May 2025
- journal article
- Published by Elsevier in Fusion Engineering and Design
- Vol. 217
Abstract
No abstract availableFunding Information
- Institute for Plasma Research
This publication has 8 references indexed in Scilit:
- Opportunities, Challenges and Prospects for Electrodeposition of Thin-Film Functional Layers in Solid Oxide Fuel Cell TechnologyMaterials, 2021
- Design and analysis of TWIN source extraction system grids with indigenous manufacturing feasibility assessmentFusion Engineering and Design, 2020
- Manufacturing technology development for an ‘angled’ accelerator grid segment for DNB Beam SourceFusion Engineering and Design, 2017
- Indigenous Manufacturing Realization of TWIN Source and Its AuxiliaryIEEE Transactions on Plasma Science, 2017
- Manufacturing and Testing of Multiaperture and Multichannel Grids for the Prototype Negative Ion Source for CFETR-NBI SystemFusion Science and Technology, 2017
- Two RF Driver-Based Negative Ion Source ExperimentIEEE Transactions on Plasma Science, 2014
- Two-RF-Driver-Based Negative Ion Source for Fusion R&DIEEE Transactions on Plasma Science, 2012
- Physics design of a 100 keV acceleration grid system for the diagnostic neutral beam for international tokamak experimental reactorReview of Scientific Instruments, 2010