Influence of Cold Work on the Resistivity of Dilute Copper Alloys
Authors:
- 1 May 1960
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review B
- Vol. 118 (3) , 654-655
Abstract
Measurements are reported of the residual electrical resistivity of a copper plus 1 atomic percent antimony alloy which had been cast and rolled. A large increase was observed on annealing, as noted by Kropschot, Garber, and Blatt. However, metallographic examination and the smallness of the change observed on subsequent rerolling suggest that their proposed mechanism of "migration" during cold work plays a much smaller part than lack of homogeneity in the cast alloy.Keywords
This publication has 5 references indexed in Scilit:
- The lattice thermal conductivity of copper alloys: Effect of plastic deformation and annealingPhilosophical Magazine, 1959
- The detection of dislocations by low temperature heat conductivity measurementsPhilosophical Magazine, 1959
- Influence of Cold Work on the Resistivity of Dilute Copper AlloysPhysical Review Letters, 1959
- Constitution of Binary AlloysJournal of the Electrochemical Society, 1958
- Physik1956