Tribological Properties of Steel/Steel, Steel/DLC and DLC/DLC Contacts in the Presence of Biodegradable Oil
Open Access
- 1 January 2019
- journal article
- research article
- Published by Japan Petroleum Institute in Journal of the Japan Petroleum Institute
- Vol. 62 (1) , 11-18
Abstract
Tribological properties of tetrahedral diamond-like carbon (ta-C DLC) coating were investigated to assess the effects of the counter surfaces under the boundary condition in the presence of biodegradable oil. The tribological tests were performed using steel/steel, steel/DLC and DLC/DLC contacts, and found that the coefficient of friction was 0.062, 0.059 and 0.048, and the wear loss was 5.57 × 10−4, 9.81 × 10−4 and 6.02 × 10−4 mm3, respectively. DLC/DLC contacts showed the lowest friction coefficient and steel/steel contacts showed the lowest wear. The high wear of steel/DLC compared to the other two contacts might be due to the high affinity between iron and carbon. The high content of oleic acid may maintain the low friction in self-mated ta-C DLC contacts and tribochemical wear was prevented by nano-scale graphitization. Therefore, material combinations are important for tribological properties and canola oil is an effective lubricant for contacts coated with ta-C DLC films.Keywords
This publication has 34 references indexed in Scilit:
- Friction, Wear, and Surface Film Formation Characteristics of Diamond-Like Carbon Thin Coating in Valvetrain ApplicationTribology Transactions, 2010
- Effect of Lubricant Additives on Tribochemical Decomposition of Hydrocarbon Oil on Nascent Steel SurfacesJournal of the Japan Petroleum Institute, 2010
- Abrasive wear testing of DLC coatings deposited on plane and cylindrical partsSurface and Coatings Technology, 2003
- Diamond-like amorphous carbonMaterials Science and Engineering: R: Reports, 2002
- Surface modification of 9Cr18 bearing steels by a metal and carbon co-plasma immersion ion implantationSurface and Coatings Technology, 2000
- Review of the tribology of diamond-like carbonWear, 1993
- Environmental impact of used motor oilScience of The Total Environment, 1989
- Clean surface reactions between diamond and steelNature, 1978
- Isothermal Elastohydrodynamic Lubrication of Point Contacts: Part III—Fully Flooded ResultsJournal of Lubrication Technology, 1977
- On Competing Failure Modes in Rolling ContactA S L E Transactions, 1967