An Approach to Compensate for the Influence of the System Normal Stiffness in CNS Direct Shear Tests
Open Access
- 8 February 2020
- journal article
- research article
- Published by Springer Nature in Rock Mechanics and Rock Engineering
- Vol. 53 (5) , 2185-2199
Abstract
Applying accurate normal load to a specimen in direct shear tests under constant normal stiffness (CNS) is of importance for the quality of the resulting data, which in turn influences the conclusions. However, deficiencies in the test system give rise to a normal stiffness, here designated as system normal stiffness, which results in deviations between the intended and actual applied normal loads. Aiming to reduce these deviations, this paper presents the effective normal stiffness approach applicable to closed-loop control systems. Validation through direct shear tests indicates a clear influence of the system normal stiffness on the applied normal load (13% for the test system used in this work). The ability of the approach to compensate for this influence is confirmed herein. Moreover, it is demonstrated that the differences between the measured and the nominal normal displacements are established by the normal load increment divided by the system normal stiffness. This further demonstrates the existence of the system normal stiffness. To employ the effective normal stiffness approach, the intended normal stiffness (user defined) and the system normal stiffness must be known. The latter is determined from a calibration curve based on normal loading tests using a stiff test dummy. Finally, a procedure is presented to estimate errors originating from the application of an approximate representation of the system normal stiffness. The approach is shown to effectively reduce the deviations between intended normal loads and the actual applied normal loads.Keywords
Funding Information
- BeFo rock engineering research foundation (BeFo 391)
This publication has 29 references indexed in Scilit:
- Developing a high capacity direct shear apparatus for the large scale laboratory testing of rock joints2013
- A New Large Dynamic Rockmechanical Direct Shear Box DeviceRock Mechanics and Rock Engineering, 2012
- Development of a New Direct Shear Testing ApparatusRock Mechanics and Rock Engineering, 2009
- Development of a Direct Shear Apparatus with Rock Joints and Its Verification TestsGeotechnical Testing Journal, 2006
- Development of an automated servo-controlled direct shear apparatus applying a constant normal stiffness conditionInternational Journal of Rock Mechanics and Mining Sciences, 2004
- A new device for investigating the hydro‐mechanical properties of rock jointsInternational Journal for Numerical and Analytical Methods in Geomechanics, 2003
- Quantifying topography and closure deformation of rock jointsInternational Journal of Rock Mechanics and Mining Sciences, 2003
- Quantitative three-dimensional description of a rough surface and parameter evolution with shearingInternational Journal of Rock Mechanics and Mining Sciences, 2002
- Shear Behavior of Regular Triangular Concrete/Rock Joints—AnalysisJournal of Geotechnical Engineering, 1989
- Experimental studies of scale effects on the shear behaviour of rock jointsInternational Journal of Rock Mechanics and Mining Sciences, 1981