A study of laser-induced surface defects in silicon and impact on electrical properties
- 14 December 2018
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 124 (22) , 223103
Abstract
Laser processing of silicon solar cells has unique advantages that offer the potential for low-cost high-efficiency photovoltaic devices. The understanding, monitoring, and control of laser-induced defects in silicon become important challenges that limit photovoltaic efficiency. In this work, the fundamental investigation of laser-induced defects was achieved by identifying defect types and origins at different laser-fluence regimes, assessing defect concentrations, and evaluating their impact on surface electrical properties and photovoltaic device performance. Studies showed that below laser melting, little degradation of electrical properties is observed, but no defects are identified; between laser melting and ablation, point defects and oxygen incorporation mainly occur; above laser ablation, dislocations and strain are primarily generated. Laser-induced dislocation density and strain are found likely to increase exponentially with laser fluence, and laser-induced strain is identified to be a possible major source of dislocation generation. In order to understand carrier recombination and charge transport in laser-processed silicon surface, we quantified the drift mobility, conductivity, carrier lifetime, and leakage current at various laser fluences and dislocation levels. The laser-defect induced degradation of surface electrical properties is governed by a probable exponential relationship with laser fluence, suggesting that laser-processing fluences near silicon melting should be carefully chosen for minimizing induced defects and electrical property degradation. Finally, the control of laser-induced defects was demonstrated through laser or furnace post annealing of laser-processed solar cell devices. After two laser-annealing steps, the open circuit voltage, fill factor, series resistance, and shunt resistance were significantly improved, resulting in an increased photovoltaic efficiency.Keywords
Funding Information
- National Science Foundation (CMMI-1436775, I/UCRC award)
- Langley Research Center (NASA Langley Professor Program)
This publication has 40 references indexed in Scilit:
- Studies of photoconductance decay method for characterization of near-surface electrical properties of semiconductorsThin Solid Films, 2011
- Efficient light trapping in silicon solar cells by ultrafast‐laser‐induced self‐assembled micro/nano structuresProgress in Photovoltaics: Research and Applications, 2011
- Laser induced defects in laser doped solar cellsProgress in Photovoltaics: Research and Applications, 2010
- Finite mobility effects on the radiative efficiency limit of-junction solar cellsPhysical Review B, 2008
- Laser-induced damage studies in silicon and silicon-based photodetectorsApplied Optics, 1996
- Electronic states associated with dislocations inp-type silicon studied by means of electric-dipole spin resonance and deep-level transient spectroscopyPhysical Review B, 1995
- Laser processing for high-efficiency Si solar cellsJournal of Applied Physics, 1982
- Incorporation of Oxygen into Silicon during Pulsed-Laser IrradiationJapanese Journal of Applied Physics, 1980
- Defects in laser damaged silicon observed by DLTSPhysica Status Solidi (a), 1978
- Normal laser damage of silicon solar cells without phase changeApplied Physics Letters, 1974