Ion Adsorption at the Rutile−Water Interface: Linking Molecular and Macroscopic Properties
Authors:
- P. FenterPFP. Fenter
- L. ChengL. Cheng
- N. C. SturchioNSN. C. Sturchio
- M. J. BedzykMBM. J. Bedzyk
- M. PředotaMPM. Předota
- A. BanduraABA. Bandura
- J. D. KubickiJKJ. D. Kubicki
- S. N. LvovSLS. N. Lvov
- P. T. CummingsPCP. T. Cummings
- A. A. ChialvoA. A. Chialvo
- ◆ M. K. Ridley◆R◆ M. K. Ridley
- 7 May 2004
- journal article
- research article
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 20 (12) , 4954-4969
Abstract
A comprehensive picture of the interface between aqueous solutions and the (110) surface of rutile (α-TiO2) is being developed by combining molecular-scale and macroscopic approaches, including experimental measurements, quantum calculations, molecular simulations, and Gouy−Chapman−Stern models. In situ X-ray reflectivity and X-ray standing-wave measurements are used to define the atomic arrangement of adsorbed ions, the coordination of interfacial water molecules, and substrate surface termination and structure. Ab initio calculations and molecular dynamics simulations, validated through direct comparison with the X-ray results, are used to predict ion distributions not measured experimentally. Potentiometric titration and ion adsorption results for rutile powders having predominant (110) surface expression provide macroscopic constraints of electrical double layer (EDL) properties (e.g., proton release) which are evaluated by comparison with a three-layer EDL model including surface oxygen proton affinities calculated using ab initio bond lengths and partial charges. These results allow a direct correlation of the three-dimensional, crystallographically controlled arrangements of various species (H2O, Na+, Rb+, Ca2+, Sr2+, Zn2+, Y3+, Nd3+) with macroscopic observables (H+ release, metal uptake, zeta potential) and thermodynamic/electrostatic constraints. All cations are found to be adsorbed as “inner sphere” species bonded directly to surface oxygen atoms, while the specific binding geometries and reaction stoichiometries are dependent on ionic radius. Ternary surface complexes of sorbed cations with electrolyte anions are not observed. Finally, surface oxygen proton affinities computed using the MUSIC model are improved by incorporation of ab initio bond lengths and hydrogen bonding information derived from MD simulations. This multitechnique and multiscale approach demonstrates the compatibility of bond-valence models of surface oxygen proton affinities and Stern-based models of the EDL structure, with the actual molecular interfacial distributions observed experimentally, revealing new insight into EDL properties including specific binding sites and hydration states of sorbed ions, interfacial solvent properties (structure, diffusivity, dielectric constant), surface protonation and hydrolysis, and the effect of solution ionic strength.Keywords
This publication has 43 references indexed in Scilit:
- Fourier-Expansion Solution of Atom Distributions in a Crystal Using X-Ray Standing WavesPhysical Review Letters, 2003
- High Temperature Microelectrophoresis Studies of the Rutile/Aqueous Solution InterfaceLangmuir, 2003
- Multilayer water adsorption on rutile TiO2(110): A first-principles studyThe Journal of Chemical Physics, 2003
- Liquid Order at the Interface of KDP Crystals with Water: Evidence for Icelike LayersPhysical Review Letters, 2003
- The surface science of titanium dioxideSurface Science Reports, 2003
- Commensurate Water Monolayer at the/Water InterfacePhysical Review Letters, 2001
- Ion Pair Formation and Primary Charging Behavior of Titanium Oxide (Anatase and Rutile)Langmuir, 2001
- The frequency-dependent conductivity of a saturated solution of ZnBr2 in water: A molecular dynamics simulationThe Journal of Chemical Physics, 1997
- Solution to the Surface Registration Problem Using X-Ray Standing WavesPhysical Review Letters, 1982
- Special points for Brillouin-zone integrationsPhysical Review B, 1976