Mechanical properties of injection molded blends of poly(ethylene‐terephthalate) and poly(amide‐6,6)
Authors:
- 1 August 1983
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 23 (11) , 637-641
Abstract
Data have been obtained regarding the tensile and impact behavior of pure poly(ethylene terephthalate) (PET) and polyamide 6,6 (PA) and blends of PA in PET in concentrations of 5, 10, 25, 30 and 35 percent by weight of PA. The measurements were carried out at −40, 23 and 70°C. Dispersion and sample preparation were carried out in a reciprocating screw injection‐molding machine. All blends exhibited brittle behavior and low strength, when compared to pure components. Although some enhancement of mechanical properties might be realized by orientation, it is suggested that the observed behavior might be attributed to the low quality of dispersion achievable in injection molding process. This conclusion is supported by microscopic evidence.Keywords
This publication has 2 references indexed in Scilit:
- Some solid‐state properties of blends of polyethylene terephthalate and polyamide‐6,6Polymer Engineering & Science, 1982
- Melt rheology of blends of semicrystalline polymers. I. Degradation and viscosity of poly(ethylene terephthalate)–polyamide-6,6 mixturesJournal of Applied Polymer Science, 1982