Tagasaste forage production systems
Authors:
Open Access
- 1 October 1990
- journal article
- research article
- Published by Wiley in New Zealand Journal of Agricultural Research
- Vol. 33 (4) , 627-634
Abstract
Production from established rows of tagasaste ( Chamaecytisus palmensis ) was measured over 2 years at Burnham and Springston in Canterbury, New Zealand using three cutting treatments (cut to 150 cm, 50 cm, or to 50 cm every alternate harvest) and four sheep‐grazing treatments (“hard” and “lax” grazing with and without a post‐graze trim to 50 cm). At Springston, annual edible production (leaf and stem less than 6 mm in diameter, in g dry matter (DM)/tree) was highest from cut (330 g) and graze/trim (360 g) treatments and lower from graze‐only treatments (190 g) ( P < 0.05). At Burnham, annual edible production was 450 g from cut treatments and 155 g from the lax graze treatment. The hard graze and graze/trim treatments at Burnham were abandoned when April grazing and subsequent frosts killed those trees without a protective canopy. Extrapolating from the most productive tagasaste treatment, a practical layout of 7500 trees/ha occupying 30% of the area would give annual yields of 2.5–3.4 t edible tagasaste DM/ha. At the present sites, with 30% tagasaste and 70% pasture, this provides an increase of up to 22% in DM/ha over pasture alone.Keywords
This publication has 5 references indexed in Scilit:
- Forage shrubs in North Island hill country 4. Chemical composition and conclusionsNew Zealand Journal of Agricultural Research, 1989
- Forage shrubs in North Island hill country 2. Sheep and goat preferencesNew Zealand Journal of Agricultural Research, 1989
- Forage shrubs in North Island hill country 1. Forage productionNew Zealand Journal of Agricultural Research, 1989
- ESTABLISHMENT AND MANAGEMENT OF TAGASASTEProceedings of the New Zealand Grassland Association, 1987
- Gorse — A resource for goats?New Zealand Journal of Crop and Horticultural Science, 1986