Light-assisted electrochemical water-splitting at very low bias voltage using metal-free polythiophene as photocathode at high pH in a full-cell setup
- 4 April 2018
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 11 (5) , 1335-1342
Abstract
We report the use of polyterthiophenes (PTTh) as a rare, combined light-harvester and catalyst for the hydrogen evolution reaction at high pH. Illuminated PTTh in combination with a MnOx anode in a two-electrode setup exhibited stable water-splitting at a bias-potential of only 0.3 V at pH 12. This confirms that PTTh used as photocathode can produce photovoltages of at least 900 mV for the hydrogen evolution reaction at high pH and is therefore a suitable match for traditional water-oxidation catalysts such as MnOx, CoOx, and RuOx. Films of PTTh were fabricated using a novel, metal-free method where iodine vapor is used as oxidant; thus, previously observed interference from metal residuals was omitted and thereby a gravimetric photo electrocatalytic conversion rate of 330 mmol(H2) h−1 g−1 was achieved in phosphate buffer (pH 7) at 0 V vs. RHE. A striking property of this new strand of polythiophene was an “inverse” correlation (compared to that predicted using the Nernstian relationship) between the onset potential for the light-assisted water reduction reaction and pH: the potential (vs. RHE) required for a given current was more positive at higher pH, which is not observed for other (photo-) electrocatalytic materials, and indicates that the charge neutralization of PTTh (rather than the pH) guides the onset potential.Keywords
Funding Information
- Ministry of Education, Culture, Sports, Science and Technology (16K05922, 18H03921, 15H00766 and 25102541)
- Waseda University
This publication has 32 references indexed in Scilit:
- Visible light driven overall water splitting using cocatalyst/BiVO4 photoanode with minimized biasPhysical Chemistry Chemical Physics, 2013
- Toward Single Crystal Thin Films of Terthiophene by Directional Crystallization Using a Thermal GradientCrystal Growth & Design, 2011
- Facile Fabrication of an Efficient Oxynitride TaON Photoanode for Overall Water Splitting into H2 and O2 under Visible Light IrradiationJournal of the American Chemical Society, 2010
- Influence of PEG‐ran‐PPG Surfactant on Vapour Phase Polymerised PEDOT Thin FilmsMacromolecular Rapid Communications, 2009
- Enhanced properties in chemically polymerized poly(terthiophene) using vapour phase techniquesReactive and Functional Polymers, 2008
- Improving performance of polymer photovoltaic devices using an annealing-free approach via construction of ordered aggregates in solutionJournal of Materials Chemistry, 2008
- Stability of highly conductive poly-3,4-ethylene-dioxythiopheneReactive and Functional Polymers, 2006
- Intrinsic excitonic luminescence in crystalline terthiophenePhysical Review B, 2005
- Vapor Phase Polymerization of Pyrrole and Thiophene Using Iron(III) Sulfonates as Oxidizing AgentsMacromolecules, 2004
- Vapor-Phase Polymerization of 3,4-Ethylenedioxythiophene: A Route to Highly Conducting Polymer Surface LayersMacromolecules, 2004