Assessment of the benefits of 3D printing of advanced thermosetting composites using process simulation and numerical optimisation
Authors:
- Giacomo StruzzieroGSGiacomo Struzziero
- Michel BarbezatMBMichel Barbezat
- Alexandros Antonios SkordosASAlexandros Antonios Skordos
Open Access
- 14 January 2023
- journal article
- retracted article
- Published by Elsevier in Additive Manufacturing
- Vol. 63
Abstract
No abstract availableKeywords
This publication has 29 references indexed in Scilit:
- Local heat transfer distribution on a smooth flat plate impinged by a slot jetInternational Journal of Heat and Mass Transfer, 2011
- Synergistic effects of zinc borate and aluminium trihydroxide on flammability behaviour of aerospace epoxy systemExpress Polymer Letters, 2009
- Experimental study and theoretical analysis of local heat transfer distribution between smooth flat surface and impinging air jet from a circular straight pipe nozzleInternational Journal of Heat and Mass Transfer, 2008
- Analysis of heat transfer in autoclave technologyPolymer Composites, 2001
- OPTIMIZED CURING OF THICK SECTION COMPOSITE LAMINATESMaterials and Manufacturing Processes, 2001
- Optimal curing for thermoset matrix composites: Thermochemical considerationsPolymer Composites, 2001
- Optimal cure cycles for the fabrication of thermosetting‐matrix compositesPolymer Composites, 1997
- Air jet impingement heat transfer at low nozzle-plate spacingsInternational Journal of Heat and Mass Transfer, 1994
- Cure Cycle Optimization for the Reduction of Processing-Induced Residual Stresses in Composite MaterialsJournal of Composite Materials, 1993
- Glass transition temperature versus conversion relationships for thermosetting polymersJournal of Polymer Science Part B: Polymer Physics, 1990