Flow Management to Control Excessive Growth of Macrophytes – An Assessment Based on Habitat Suitability Modeling
Open Access
- 19 March 2018
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Plant Science
- Vol. 9, 356
Abstract
Mediterranean rivers in intensive agricultural watersheds usually display outgrowths of macrophytes – notably alien species – due to a combination of high concentrations of nutrients in the water runoff and low flows resulting from water abstraction for irrigation. Standard mechanical and chemical control is used to mitigate the problems associated with excessive growth of plant biomass: mainly less drainage capacity and higher flood risk. However, such control measures are cost and labor-intensive and do not present long-term efficiency. Although the high sensitivity of aquatic vegetation to instream hydraulic conditions is well known, management approaches based on flow management remain relatively unexplored. The aim of our study was therefore to apply physical habitat simulation techniques promoted by the Instream Flow Incremental Method (IFIM) to aquatic macrophytes – the first time it has been applied in this context – in order to model shifts in habitat suitability under different flow scenarios in the Sorraia river in central Portugal. We used this approach to test whether the risk of invasion and channel encroachment by nuisance species can be controlled by setting minimum annual flows. We used 960 randomly distributed survey points to analyze the habitat suitability for the most important aquatic species (including the invasive Brazilian milfoil Myriophyllum aquaticum, Sparganium erectum, and Potamogeton crispus) in regard to the physical parameters ‘flow velocity,’ ‘water depth,’ and ‘substrate size’. We chose the lowest discharge period of the year in order to assess the hydraulic conditions while disturbances were at a low-point, thus allowing aquatic vegetation establishment and subsistence. We then used the two-dimensional hydraulic River2D software to model the potential habitat availability for different flow conditions based on the site-specific habitat suitability index for each physical parameter and species. Our results show that the growth and distribution of macrophytes in the hydrologically stable vegetation period is primarily a function of the local physical instream condition. Using site-specific preference curves and a two-dimensional hydraulic model, it was possible to determine minimum annual flows that might prevent the excessive growth and channel encroachment caused by Myriophyllum aquaticum.Keywords
This publication has 65 references indexed in Scilit:
- Tradeoffs in river restoration: Flushing flows vs. hydropower generation in the Lower Ebro River, SpainJournal of Hydrology, 2014
- Species distribution models in conservation biogeography: developments and challengesDiversity and Distributions, 2013
- Effectiveness of 1D and 2D hydraulic models for instream habitat analysis in a braided riverEcological Engineering, 2012
- ASSESSING THE GEOMORPHIC EFFECTS OF A FLUSHING FLOW IN A LARGE REGULATED RIVERRiver Research and Applications, 2012
- Self‐organised patchiness and scale‐dependent bio‐geomorphic feedbacks in aquatic river vegetationEcography, 2011
- Instream physical habitat modelling types: an analysis as stream hydromorphological modelling tools for EU water resource managersInternational Journal of River Basin Management, 2010
- Alien plants in checklists and floras: towards better communication between taxonomists and ecologistsTaxon, 2004
- Predictive Models of Fish Species Distributions: A Note on Proper Validation and Chance PredictionsTransactions of the American Fisheries Society, 2002
- Quantifying the effects of stream discharge on summer river temperatureHydrological Sciences Journal, 1998
- A review of methods for the assessment of prediction errors in conservation presence/absence modelsEnvironmental Conservation, 1997