Measurement of the sound velocities behind the shock wave front in tin
- 1 January 2012
- journal article
- Published by Pleiades Publishing Ltd in Combustion, Explosion, and Shock Waves
- Vol. 48 (1) , 112-118
Abstract
Results obtained by two methods for the measurement of the sound velocity in tim samples (initial density of 7.28 g/cm3 and impurities less than 0.085%) are presented. In the range of pressures from 30 to 150 GPa, the sound velocity is determined by the overtake method with the use of indicator liquids. The luminescence of the indicator liquids is detected by photodiode-based optical gauges. At shock compression pressures of 5–18 GPa, the sound velocity in tin is measured by the counter release method with the use of manganin-based gauges. The experimental data are compared with numerical predictions and results of other authors. The boundaries of the tin melting region on the shock adiabat are found.Keywords
This publication has 8 references indexed in Scilit:
- MEASUREMENT OF SOUND VELOCITIES IN SHOCK-COMPRESSED TIN UNDER PRESSURES UP TO 150 GPaAIP Conference Proceedings, 2009
- Successive phase transitions of tin under shock compressionApplied Physics Letters, 2008
- Properties of Shock‐Compressed Carbogal. Equations of State for Carbogal and PlexiglasCombustion, Explosion, and Shock Waves, 2004
- Wide-range multi-phase equations of state for metalsNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 1998
- Tin at high pressure: An energy-dispersive x-ray-diffraction study to 120 GPaPhysical Review B, 1989
- Near-infrared photoluminescence bands in diamondPhysical Review B, 1989
- The use of in-material stress gauges for estimating the dynamic yield strength of shock-loaded solidsJournal of Applied Physics, 1984
- Optical technique for determining rarefaction wave velocities at very high pressuresReview of Scientific Instruments, 1982