Development and dosimetric verification of 3D customized bolus in head and neck radiotherapy
Open Access
- 14 April 2022
- journal article
- research article
- Published by Oxford University Press (OUP) in Journal of Radiation Research
- Vol. 63 (3) , 428-434
Abstract
The commercial flat bolus cannot form perfect contact with the irregular surface of the patient’s skin, resulting in an air gap. The purpose of this study was to evaluate the feasibility of using a 3D customized bolus from silicone rubber. The silicone rubber boluses were studied in basic characteristics. The 3D customized bolus was fabricated at the nose, cheek and neck regions. The point dose and planar dose differences were evaluated by comparing with virtual bolus. The hardness, thickness, density, Hounsfield unit (HU) and dose attenuation of the customized bolus were quite similar to a commercial bolus. When a 3D customized bolus was placed on the RANDO phantom, it can significantly increase buildup region doses and perfectly fit against the irregular surface shape. The average point dose differences of 3D customized bolus were −1.1%, while the commercial bolus plans showed −1.7%. The average gamma results for planar dose differences comparison of 3D customized bolus were 93.9%, while the commercial bolus plans were reduced to 91.9%. Overall, A silicone rubber bolus produced the feasible dosimetric properties and could save cost compared to a commercial bolus. The 3D printed customized bolus is a good buildup material and could potentially replace and improve treatment efficiency.Keywords
Funding Information
- Chulalongkorn University (RA63/072)
This publication has 13 references indexed in Scilit:
- A Patient-Specific Polylactic Acid Bolus Made by a 3D Printer for Breast Cancer Radiation TherapyPLOS ONE, 2016
- Customized 3D Printed Bolus for Breast Reconstruction for Modified Radical Mastectomy (MRM)Progress in Medical Physics, 2016
- A Customized Bolus Produced Using a 3-Dimensional Printer for RadiotherapyPLOS ONE, 2014
- New Technique for Developing a Proton Range Compensator With Use of a 3-Dimensional PrinterInternational Journal of Radiation Oncology - Biology - Physics (IJROBP), 2014
- Innovations in 3D printing: a 3D overview from optics to organsBritish Journal of Ophthalmology, 2013
- EFFECT OF WETNESS LEVEL ON THE SUITABILITY OF WET GAUZE AS A SUBSTITUTE FOR SUPERFLAB® AS A BOLUS MATERIAL FOR USE WITH 6 MV PHOTONSVeterinary Radiology & Ultrasound, 2009
- Quality Assurance of Radiation Therapy Planning Systems: Current Status and Remaining ChallengesInternational Journal of Radiation Oncology - Biology - Physics (IJROBP), 2008
- An investigation of central axis depth dose distribution perturbation due to an air gap between patient and bolus for electron beamsAustralasian Physics & Engineering Sciences in Medicine, 2007
- Effects on skin dose from unwanted air gaps under bolus in photon beam radiotherapyRadiation Measurements, 2000
- Surface dose perturbation due to air gap between patient and bolus for electron beamsMedical Physics, 1993