Optimization of Laboratory Molding Techniques for Nordic Dry Deep Mixing
Authors:
- 25 April 2022
- journal article
- research article
- Published by ASTM International in Geotechnical Testing Journal
- Vol. 45 (4) , 837-854
Abstract
The dry deep mixing method is a widely used stabilization method in the Nordic countries to improve the strength and deformation properties of soft clays. In engineering practice, laboratory tests normally precede in situ stabilization; however, previous studies have shown considerable differences between field and laboratory stabilization. The type of laboratory molding technique will determine how representative the specimen is compared with field conditions. A key property is the amount of entrapped air in the stabilized clay, which is shown to be very low in field stabilization. This paper presents a study of two different Norwegian molding techniques, including different optimizations to reduce the amount of entrapped air. The specimens are tested for density and strength, and it is shown that the strength increases with increasing density of the stabilized clay. Consequently, there is an inverse relationship between the amount of entrapped air and the strength, showing the importance of reducing the amount of entrapped air in laboratory specimens as much as possible. It is also shown that the wet mixing method does not necessarily give the same strength development as dry deep mixing given the same water to binder ratio.Keywords
This publication has 20 references indexed in Scilit:
- Experimental evaluation of stress concentration ratio of model stone columns strengthened by additivesInternational Journal of Physical Modelling in Geotechnics, 2013
- Key Parameters for Strength Control of Artificially Cemented SoilsJournal of Geotechnical and Geoenvironmental Engineering, 2007
- Physical modelling of consolidation behaviour of a composite foundation consisting of a cement-mixed soil column and untreated soft marine clayGéotechnique, 2006
- Consolidation stress effects on the strength of stabilised Swedish soilsProceedings of the Institution of Civil Engineers - Ground Improvement, 2006
- Uniformity of lime-cement columns for deep mixing: a field studyProceedings of the Institution of Civil Engineers - Ground Improvement, 2005
- Ultimate Bearing Capacity of Soft Clays Reinforced by a Group of Columns—Application to a Deep Mixing TechniqueSoils and Foundations, 2004
- Assessment of strength development in cement-admixed high water content clays with Abrams' law as a basisGéotechnique, 2003
- Interaction mechanism between deep mixing column and surrounding clay during installationCanadian Geotechnical Journal, 2003
- Stabilising effects of different binders in some Swedish soilsProceedings of the Institution of Civil Engineers - Ground Improvement, 2003
- Engineering Behavior of Cement Stabilized Clay at High Water ContentSoils and Foundations, 2001