Enhanced sensitivity in a butterfly gyroscope with a hexagonal oblique beam
Open Access
- 26 March 2015
- journal article
- conference paper
- Published by AIP Publishing in AIP Advances
- Vol. 5 (4) , 041331
Abstract
A new approach to improve the performance of a butterfly gyroscope is developed. The methodology provides a simple way to improve the gyroscope’s sensitivity and stability, by reducing the resonant frequency mismatch between the drive and sense modes. This method was verified by simulations and theoretical analysis. The size of the hexagonal section oblique beam is the major factor that influences the resonant frequency mismatch. A prototype, which has the appropriately sized oblique beam, was fabricated using precise, time-controlled multilayer pre-buried masks. The performance of this prototype was compared with a non-tuned gyroscope. The scale factor of the prototype reaches 30.13 mV/ ˚/s, which is 15 times larger than that obtained from the non-tuned gyroscope. The bias stability of the prototype is 0.8 ˚/h, which is better than the 5.2 ˚/h of the non-tuned devices.Keywords
Funding Information
- National University of Defense Technology Research Project (JC14-03-01)
This publication has 10 references indexed in Scilit:
- Improvement of mechanical performance for vibratory microgyroscope based on sense mode closed-loop controlJournal of Micro/Nanolithography, MEMS, and MOEMS, 2013
- Epitaxially-encapsulated polysilicon disk resonator gyroscope2013
- A novel fabrication method based on an after thermal oxidation process for the realization of silicon-beams with normative polygon cross sections shapesMicrosystem Technologies, 2012
- A mode-matched 0.9 MHZ single proof-mass dual-axis gyroscope2011
- Sub-degree-per-hour silicon MEMS rate sensor with 1 million Q-factor2011
- A 0.1°/HR bias drift electronically matched tuning fork microgyroscope2008
- Bulk micromachined angular rate sensor based on the 'butterfly'-gyro structure2002
- High-resolution microgyroscope using vibratory motion adjustment technologySensors and Actuators A: Physical, 2001
- Analysis of a highly sensitive silicon gyroscope with cantilever beam as vibrating massSensors and Actuators A: Physical, 1996
- Micromachined gyroscopesSensors and Actuators A: Physical, 1994