Inversion of multicomponent, multiazimuth, walkaway VSP data for the stiffness tensor
- 1 January 2003
- journal article
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 68 (3) , 1022-1031
Abstract
Vertical seismic profiling (VSP), an established technique, can be used for estimating in-situ anisotropy that might provide valuable information for characterization of reservoir lithology, fractures, and fluids. The P-wave slowness components, conventionally measured in multiazimuth, walkaway VSP surveys, allow one to reconstruct some portion of the corresponding slowness surface. A major limitation of this technique is that the P-wave slowness surface alone does not constrain a number of stiffness coefficients that may be crucial for inferring certain rock properties. Those stiffnesses can be obtained only by combining the measurements of P-waves with those of S (or PS) modes. Here, we extend the idea of Horne and Leaney, who proved the feasibility of joint inversion of the slowness and polarization vectors of P- and SV-waves for parameters of transversely isotropic media with a vertical symmetry axis (VTI symmetry). We show that there is no need to assume a priori VTI symmetry or any other specific type of anisotropy. Given a sufficient polar and azimuthal coverage of the data, the polarizations and slownesses of P and two split shear (S1 and S2) waves are sufficient for estimating all 21 elastic stiffness coefficients cij that characterize the most general triclinic anisotropy. The inverted stiffnesses themselves indicate whether or not the data can be described by a higher-symmetry model. We discuss three different scenarios of inverting noise-contaminated data. First, we assume that the layers are horizontal and laterally homogeneous so that the horizontal slownesses measured at the surface are preserved at the receiver locations. This leads to a linear inversion scheme for the elastic stiffness tensor c. Second, if the S-wave horizontal slowness at the receiver location is unknown, the elastic tensor c can be estimated in a nonlinear fashion simultaneously with obtaining the horizontal slowness components of S-waves. The third scenario includes the nonlinear inversion for c using only the vertical slowness components and the polarization vectors of P- and S-waves. We find the inversion to be stable and robust for the first and second scenarios. In contrast, errors in the estimated stiffnesses increase substantially when the horizontal slowness components of both P- and S-waves are unknown. We apply our methodology to a multiazimuth, multicomponent VSP data set acquired in Vacuum field, New Mexico, and show that the medium at the receiver level can be approximated by an azimuthally rotated orthorhombic model.Keywords
This publication has 11 references indexed in Scilit:
- Local Determination of Weak Anisotropy Parameters from qP -wave Slowness and Particle Motion MeasurementsPure and Applied Geophysics, 2002
- Alford rotation, ray theory, and crossed-dipole geometryGeophysics, 2000
- Short note: Polarization and slowness component inversion for TI anisotropyGeophysical Prospecting, 2000
- Estimation of fracture parameters from reflection seismic data—Part II: Fractured models with orthorhombic symmetryGeophysics, 2000
- Estimation of fracture parameters from reflection seismic data—Part III: Fractured models with monoclinic symmetryGeophysics, 2000
- 3-D moveout velocity analysis and parameter estimation for orthorhombic mediaGeophysics, 1999
- Anisotropic parameters and P-wave velocity for orthorhombic mediaGeophysics, 1997
- Determination of anisotropic velocity models from walkaway VSP data acquired in the presence of dipGeophysics, 1997
- An exact inversion for anisotropic moduli from phase slowness dataJournal of Geophysical Research, 1994
- Transversely isotropic phase velocity analysis from slowness estimatesJournal of Geophysical Research, 1990