Mass flash reduction strategies in friction stir processing of aluminum alloys: A review
Open Access
- 14 August 2024
- journal article
- review article
- Published by Wiley in Engineering Reports
- Vol. 6 (10)
Abstract
Friction Stir Processing (FSP) has become a famous solid‐state technology for the fabrication of a wide range of aluminum alloy‐based composites that today find multiple applications across the various metal industries. Generation of revolving, ribbon, bulk, excessive or mass flash as it is generally termed has been a common problem in numerous FSP works. When confronted by this challenge, many researchers apply different experimental and numerical modeling approaches or strategies to reduce the mass flash to practically acceptable limits since it often leads to undesirable loss of material and is also an unwanted defect. This subject is deficiently reviewed, and it therefore becomes the thrust of this paper, to investigate the common trends in mass flash generation during FSP and its commonly employed reduction strategies. Mass flash is caused by high rotational speed at low travel speed and vice versa, flat shoulder, no and low tilt angles, high plunge depth, axial force, and travel force. Mass flash causes material loss, loss of volume fraction control target, material thinning, and leads to poor quality fabrications. Mass flash reduction strategies include the use of high tool tilt angles, concaved tool shoulder, proportional rotational speed and travel speed, and optimal plunge depth, axial force and travel speed as supported by both the experimental and numerical modeling studies.Keywords
This publication has 34 references indexed in Scilit:
- A comprehensive review of friction stir techniques in structural materials and alloys: challenges and trendsJournal of Materials Research and Technology, 2022
- Multivariate optimization of mechanical and microstructural properties of welded joints by FSW methodEngineering Failure Analysis, 2022
- Experimental data on surface roughness and force feedback analysis in friction stir processed AA7075 – T651 aluminium metal compositesData in Brief, 2019
- Effect of multi-pass friction stir processing on the microstructure, mechanical and wear properties of AA5083/ZrO2 nanocompositesJournal of Alloys and Compounds, 2017
- The effect of friction stir vibration welding process on characteristics of SiO2 incorporated jointJournal of Materials Processing Technology, 2017
- Effect of carbonaceous reinforcements on the mechanical and tribological properties of friction stir processed Al6061 alloyMaterials & Design, 2016
- Surface composites by friction stir processing: A reviewJournal of Materials Processing Technology, 2015
- Fabrication of Al5083/B4C surface composite by friction stir processing and its tribological characterizationJournal of Materials Research and Technology, 2015
- Microstructural and Mechanical Characteristics of AA2014/SiC Surface Composite Fabricated by Friction Stir ProcessingMaterials Today: Proceedings, 2015
- Reinforcement strategies for producing functionally graded materials by friction stir processing in aluminium alloysJournal of Materials Processing Technology, 2013