Zn ( O , S ) buffer layers by atomic layer deposition in Cu(In,Ga)Se2 based thin film solar cells: Band alignment and sulfur gradient
Top Cited Papers
- 15 August 2006
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 100 (4) , 044506
Abstract
Thin film solar cells with the structure are studied for varying thickness and sulfur content of the buffer layer. These layers were deposited by atomic layer deposition (ALD) at . Devices with no or small concentrations of sulfur in the buffer layer show low open-circuit voltages. This is explained by the cliff, or negative conduction-band offset (CBO), of measured by photoelectron spectroscopy (PES) and optical methods for the interface. Devices with buffer layers exhibit very low photocurrent. This is expected from the large positive CBO (spike) of measured for the interface. For devices with buffer layers, two different deposition recipes were found to yield devices with efficiencies equal to or above reference devices in which standard buffer layers were used; ultrathin layers with ratios of 0.8–0.9, and layers of around with average ratios of 0.3. The sulfur concentration increases towards the CIGS interface as revealed by transmission electron microscopy and in vacuo PES measurements. The occurrence of this sulfur gradient in is explained by longer incubation time for growth compared to growth. For the film with high sulfur content, the CBO is large which causes blocking of the photocurrent unless the film is ultrathin. For the film with lower sulfur content, a CBO of is obtained which is close to ideal, according to simulations. Efficiencies of up to 16.4% are obtained for devices with this buffer layer.
Keywords
This publication has 24 references indexed in Scilit:
- Determination of dominant recombination paths in Cu(In,Ga)Se2 thin-film solar cells with ALD–ZnO buffer layersThin Solid Films, 2005
- High‐efficiency copper indium gallium diselenide (CIGS) solar cells with indium sulfide buffer layers deposited by atomic layer chemical vapor deposition (ALCVD)Progress in Photovoltaics: Research and Applications, 2003
- High-efficiency Cd-free CIGSS thin-film solar cells with solution grown zinc compound buffer layersSolar Energy Materials and Solar Cells, 2001
- Progress in large-area Cu(InGa)Se2-based thin-film modules with a Zn(O,S,OH)x buffer layerSolar Energy Materials and Solar Cells, 2001
- Improvement in Performances of ZnO:B/i-ZnO/Cu(InGa)Se2 Solar Cells by Surface Treatments for Cu(InGa)Se2Japanese Journal of Applied Physics, 2000
- A comprehensive characterization of the interfaces in Mo/CIS/CdS/ZnO solar cell structuresSolar Energy Materials and Solar Cells, 1996
- Zinc oxysulfide thin films grown by atomic layer depositionChemistry of Materials, 1992
- Composition-Dependent Appearance of Amorphous Phase in ZnSxO1-x System and its StabilityJapanese Journal of Applied Physics, 1986
- Microscopic study of semiconductor heterojunctions: Photoemission measurement of the valance-band discontinuity and of the potential barriersPhysical Review B, 1983
- Optical Properties and Electronic Structure of Amorphous GermaniumPhysica Status Solidi (b), 1966