Rotor Design Options for Improving Tiltrotor Whirl-Flutter Stability Margins
Authors:
- C. W. AcreeCAC. W. Acree
- R. J. PeyranRPR. J. Peyran
- Wayne JohnsonWJWayne Johnson
- 1 April 2001
- journal article
- Published by AHS International dba Vertical Flight Society in Journal of the American Helicopter Society
- Vol. 46 (2) , 87-95
Abstract
Rotor design changes intended to improve tiltrotor whirl‐flutter stability margins Were analyzed. A baseline analytical model similar to the XV‐15 (23% thick wing) Was established, and then a 15% thick wing Was designed to he representative of a high‐speed tiltrotor. While the thinner wing has lower drag, it also has lower stiffness, reducing whirl‐flutter stability. The rotor blade design was modified to increase the stability speed margin for the thin‐wing design. Small rearward offsets of the aerodynamic‐center locus with respect to the blade elastic axis created, large increases in the stability boundary. The effect was strongest for offsets at the outboard part of the blade, where an offset of the aerodynamic center by 10% of tip chord improved the stability margin by over 100 knots. Forward offsets of the blade center of gravity had similar but less pronounced effects. Equivalent results were seen for swept‐tip blades. Combinations of tip sweep, control‐system stiffness, and delta‐three were also investigated. A limited investigation of blade loads in helicopter and airplane configuration indicated that proper choice of parametric variations can avoid excessive increases in rotor loads.Keywords
This publication has 7 references indexed in Scilit:
- Aeroelastic Tailoring for Stability Augmentation and Performance Enhancements of Tiltrotor AircraftJournal of the American Helicopter Society, 2000
- Aeroelastic Analysis of Advanced Geometry Tiltrotor AircraftJournal of the American Helicopter Society, 1998
- The Influence of Composite Induced Couplings on Tiltrotor Whirl Flutter StabilityJournal of the American Helicopter Society, 1998
- Results of an Aeroelastic Tailoring Study for a Composite Tiltrotor WingJournal of the American Helicopter Society, 1997
- Parametric Studies for Tiltrotor Aeroelastic Stability in Highspeed FlightJournal of the American Helicopter Society, 1993
- The Stopped‐Rotor Variant of the Proprotor VTOL AircraftJournal of the American Helicopter Society, 1970
- The Effect of Positive Pitch-flap Coupling (Negative δ3) on Rotor Blade Motion Stability and FlappingJournal of the American Helicopter Society, 1969