Modeling of Phases Adhesion in Composite Materials Based on Spring Finite Element with Zero Length
- 20 September 2018
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 780, 3-9
Abstract
A new numerical method for homogenization of elastic properties of dispersedly-reinforced composites was presented. The method takes into account special model of adhesive contact. Homogenization of properties was performed by averaging the solutions of boundary value problems on representative volume cell (RVC) using the finite element method (FEM). A new approach of calculation of components of effective tensor of elastic moduli was proposed. A heterogeneous finite element model with elements of two types was built: three-dimensional tetrahedron elements for every phases and spring element with zero-length for adhesion layer with zero-thickness. The results of homogenization of elastic properties of dispersedly-reinforced composites with variable stiffness of the adhesive layer between phases were obtained and analyzed. The homogenization results were compared with the available experimental data.Keywords
This publication has 16 references indexed in Scilit:
- Computer-aided Analysis of Micromechanics and Damage of Composite Materials Based on Multiscale Homogenization MethodMRS Proceedings, 2013
- Multicriteria optimization based on neural network, fuzzy and neuro-fuzzy approximation of decision maker’s utility functionOptical Memory and Neural Networks, 2012
- Numerical modeling of composites with multiscale microstructureBulletin of the Russian Academy of Sciences: Physics, 2011
- A micromechanical model for effective elastic properties of particulate composites with imperfect interfacial bondsInternational Journal of Solids and Structures, 2005
- A three-dimensional finite element model for stress analysis of adhesive jointsInternational Journal of Adhesion and Adhesives, 2002
- Viscoelastic interphases in polymer–matrix composites: theoretical models and finite-element analysisComposites Science and Technology, 2001
- Parameter identification of a time-dependent elastic-damage interface model for the simulation of debonding in compositesComposites Science and Technology, 2001
- An interface model for the prediction of Young's modulus of layered silicate‐elastomer nanocompositesPolymer Composites, 1998
- Experimental values for the elastic constants of a particulate-filled glassy polymerJournal of Research of the National Bureau of Standards Section A: Physics and Chemistry, 1976
- A theoretical study of the effect of an interfacial layer on the properties of compositesPolymer Engineering & Science, 1974