Rheological Property and Stress Development during Drying of Tape‐Cast Ceramic Layers
Authors:
- 1 December 1996
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 79 (12) , 3225-3234
Abstract
Rheological property and stress development of tape‐cast ceramic layers derived from nonaqueous alumina (A1 2 O 3 )‐poly(vinyl butyral) (PVB) suspensions were observed during drying. Casting suspensions exhibited strong shear‐thinning behavior, with a low shear Newtonian plateau apparent viscosity >10 2 Pa . s. The apparent suspension viscosity displayed a power‐law dependence on the A1 2 O 3 volume fraction during the initial stage of drying (max ) of 1.37‐0.77 MPa were observed for plasticized tapes cast at gap heights of 150‐400 μm. In contrast, nonplasticized tapes of similar thickness displayed a more gradual stress increase, with σ max values approximately an order of magnitude higher than their plasticized counterparts. The stress histories of the corresponding binder coatings were quite similar to the tape‐cast layers, albeit slightly lower σ max values were observed. Stresses decayed beyond σ max with a logarithmic time dependence to an almost constant value of 0.2‐0.4 MPa for the plasticized tapes. Based on these observations, process methodologies have been offered to minimize stress development and retention in tape‐cast ceramic layersKeywords
This publication has 19 references indexed in Scilit:
- Drying of Granular Ceramic Films: II, Drying Stress and Saturation UniformityJournal of the American Ceramic Society, 1993
- Drying of Granular Ceramic Films: I, Effect of Processing Variables on Cracking BehaviorJournal of the American Ceramic Society, 1993
- COMPETING DRYING AND REACTION MECHANISMS IN THE FORMATION OF SOL-TO-GEL FILMS, FIBERS, AND SPHERESDrying Technology, 1992
- Aqueous Processing of Mullite‐Containing Green SheetsJournal of the American Ceramic Society, 1991
- Drying gelsJournal of Non-Crystalline Solids, 1989
- Ceramic Packaging1989
- Drying gelsJournal of Non-Crystalline Solids, 1987
- Review of multilayer ceramics for microelectronic packagingJournal of Physics and Chemistry of Solids, 1984
- The origin of residual internal stress in solvent‐cast thermoplastic coatingsJournal of Applied Polymer Science, 1979
- FABRICATION OF THIN CERAMIC SHEETS FOR CAPACITORS*Journal of the American Ceramic Society, 1947