MODELAGEM E ESTUDO DE CONCENTRADORES SOLARES PLANOS
Open Access
- 13 December 2016
- conference paper
- Published by Associação Brasileira de Energia Solar in Anais Congresso Brasileiro de Energia Solar - CBENS
- p. 1-8
Abstract
The use of solar energy for the generation of electric energy with photovoltaic modules is increasing rapidly for some years but, despite this growth, initial investment is still high. One of the solutions to reduce system cost is through the incorporation of solar concentrators, which reduce the required area of photovoltaic modules for the generation of the same amount of energy. However, as the total incident radiation increases, module temperature increases reducing module efficiency. This work evaluates the energy generated by photovoltaic modules for different geometries of flat solar concentrators with a single-mirror thorough simulation. This study also evaluates the difference in generated energy if temperature effects are considered in system modelling. Simulations were evaluated for the city of Viçosa, MG (20° S). The system model which considered temperature effects resulted in energy generation about 8.2 % smaller. The potential use of concentrating solar systems in different locations was evaluated using data from five cities with different latitudes and in both hemispheres and it was found that regions with lower values of temperature showed higher potential for installation of higher concentration ratios solar systems. O uso da energia solar para geração de energia elétrica através de painéis fotovoltaicos está crescendo a uma alta velocidade já a alguns anos, mas, apesar deste crescimento, o investimento em sistemas fotovoltaicos ainda é elevado. Uma das soluções usadas para reduzir este investimento inicial se dá através do uso de concentradores, que reduzem a quantidade de módulos necessários para gerar uma mesma quantidade de energia. No entanto, ao se aumentar a radiação incidente sobre uma célula solar há, também, um aumento na temperatura da célula, o que resulta em uma redução no rendimento da célula. Este estudo avalia as variações na quantidade de energia gerada pelos módulos para diferentes geometrias de concentradores solares planos, com um espelho, e compara os resultados obtidos considerando os efeitos da temperatura e sem considerar estes efeitos, que normalmente são usados para dimensionamento de sistemas fotovoltaicos. Os cálculos foram realizados para a cidade de Viçosa, MG (20º S). Foi obtido que o modelo que considera a temperatura apresenta valores de energia cerca de 8.2% menor que o segundo modelo. O potencial de uso de concentradores em diferentes locais foi avaliado com base em cinco locais, observando-se que a medida que o local apresenta temperaturas mais baixas, há um maior potencial para uso de concentradores com maior razão de concentração sem alteração na tecnologia de célula solar fotovoltaica.Keywords
This publication has 12 references indexed in Scilit:
- Non-uniform illumination in concentrating solar cellsRenewable and Sustainable Energy Reviews, 2012
- Review of modelling details in relation to low-concentration solar concentrating photovoltaicRenewable and Sustainable Energy Reviews, 2011
- On the temperature dependence of photovoltaic module electrical performance: A review of efficiency/power correlationsSolar Energy, 2009
- Enhanced heat dissipation of V-trough PV modules for better performanceSolar Energy Materials and Solar Cells, 2008
- Calculation of the polycrystalline PV module temperature using a simple method of energy balanceRenewable Energy, 2006
- Correlation models of diffuse solar-radiation applied to the city of São Paulo, BrazilApplied Energy, 2002
- Modeling the solar irradiation on flat plate collectors augmented with planar reflectorsSolar Energy, 1995
- External reflectors for large solar collector arrays, simulation model and experimental resultsSolar Energy, 1993
- Solar Engineering of Thermal ProcessesAmerican Journal of Physics, 1985
- Stationary reflector-augmented flat-plate collectorsSolar Energy, 1982