Scandate Dispenser Cathode Fabrication for A High-Aspect-Ratio High-Current-Density Sheet Beam Electron Gun
Authors:
- 4 April 2012
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 59 (6) , 1792-1798
Abstract
A high-current-density scandate tungsten dispenser cathode was used for the demonstration of a 25 : 1-aspect-ratio 750-A/cm2 -current-density sheet beam for the Defence Advanced Research Project Agency High-Frequency Integrated Vacuum Electronics (HiFIVE) program intended for the realization of a wideband ( ~ 30%) 220-GHz traveling wave tube. The elliptical cathode with homogeneous microstructure was made from 1-2-μm-size tungsten powder added with nanosized Scandia using the sol-gel method; it has a current density of up to 160 A/cm2 at 1050 °C. A sheet beam gun analyzer was built to test the terahertz sheet beam gun and determine the size and current density of a sheet electron beam produced by the impregnated scandate tungsten dispenser cathode. A sheet electron beam with an aspect ratio of 12.5 : 1 with a current density exceeding 375 A/cm2 has been obtained using a BVERI impregnated scandate dispenser cathode without magnetic compression; further magnetic field compression would give the final current density of 750 A/cm2.Keywords
This publication has 25 references indexed in Scilit:
- High Current Density and Long-Life Nanocomposite Scandate Dispenser Cathode FabricationIEEE Transactions on Electron Devices, 2011
- 17.5: High current density and long life nanocomposite scandate dispenser cathode fabrication2010
- High current density and long life nanocomposite scandate dispenser cathode fabrication2009
- Development of High Current-Density Cathodes With Scandia-Doped Tungsten PowdersIEEE Transactions on Electron Devices, 2007
- Characteristics of scandate-impregnated cathodes with sub-micron scandia-doped matricesApplied Surface Science, 2005
- Investigation and application of impregnated scandate cathodesApplied Surface Science, 2003
- Performance of a high-power klystron using a BI cathode in the KEK electron linacApplied Surface Science, 1999
- Emission properties of top-layer scandate cathodes prepared by LADApplied Surface Science, 1997
- Investigation of scandate cathodes: emission, fabrication, and activation processesIEEE Transactions on Electron Devices, 1989
- Properties and manufacture of top-layer scandate cathodesApplied Surface Science, 1986