Ultrasonic Measurement of Rolling Bearing Lubrication Using Piezoelectric Thin Films
- 3 December 2008
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 131 (1) , 011502
Abstract
This paper describes the measurement of lubricant-film thickness in a rolling element bearing using a piezoelectric thin film transducer to excite and receive ultrasonic signals. High frequency (200 MHz) ultrasound is generated using a piezoelectric aluminum nitride film deposited in the form of a very thin layer onto the outer bearing raceway. This creates a transducer and electrode combination of total thickness of less than . In this way the bearing is instrumented with minimal disruption to the housing geometry and the oil-film can be measured noninvasively. The high frequency transducer generates a fine columnar beam of ultrasound that has dimensions less than the typical lubricated contact ellipse. The reflection coefficient from the lubricant-layer is then measured from within the lubricated contact and the oil-film thickness extracted via a quasistatic spring model. The results are described on a deep groove 6016 ball bearing supporting an 80 mm shaft under normal operating conditions. Good agreement is shown over a range of loads and speeds with lubricant-film thickness extracted from elastohydrodynamic lubrication theory.
Keywords
This publication has 13 references indexed in Scilit:
- A review on machinery diagnostics and prognostics implementing condition-based maintenanceMechanical Systems and Signal Processing, 2006
- Oil film measurment in polytetrafluoroethylene-faced thurst pad bearings for hydrogenerator applicationsProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2006
- A Method for the Measurement of Hydrodynamic Oil Films Using Ultrasonic ReflectionTribology Letters, 2004
- A method of temperature monitoring in fluid film bearingsTribology International, 2004
- The measurement of lubricant–film thickness using ultrasoundProceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2003
- ASSESSMENT OF GEAR DAMAGE MONITORING TECHNIQUES USING VIBRATION MEASUREMENTSMechanical Systems and Signal Processing, 2001
- Analysis of grease lubrication of a ball bearing using acoustic emission measurementProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2001
- An on-line monitoring system for oil-film, pressure and temperature distributions in large-scale hydro-generator bearingsMeasurement Science and Technology, 1999
- The Development of a Spacer Layer Imaging Method (SLIM) for Mapping Elastohydrodynamic ContactsTribology Transactions, 1996
- A Model for the Influence of Pressure on the Bulk Modulus and the Influence of Temperature on the Solidification Pressure for Liquid LubricantsJournal of Tribology, 1987