Impact of air‐abrasion on fracture load and failure type of veneered anterior Y‐TZP crowns before and after chewing simulation
- 16 June 2012
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 100B (6) , 1683-1690
Abstract
The purpose of this study was to determine the fracture load and failure types of veneered zirconia crowns that were air-abraded on either the veneering or cementation surface. Fracture loads were determined before and after chewing simulation. Standardized Y-TZP frameworks (n = 360) for canines were fabricated and divided into one control group (n = 72) and 12 test groups (n = 24). The test groups were air-abraded using alumina powder (10 s, 2 bar, distance: 10 mm) with particle size of 50 μm resp. 110 μm and veneered with one of the veneering ceramics: Triceram, Zirox, or VITA VM9. The crowns were cemented on their corresponding CoCr abutment. The initial fracture load was measured in one half of each group (n = 12), and the other half (n = 12) was subjected to chewing cycling. The data were analyzed using three-way and one-way ANOVA, a post-hoc Scheffé test, two sample Student's t-test, and Weibull statistics (p < 0.05). Thus, nonaged, air-abraded groups of two veneering ceramics (Triceram, VITA VM9) showed higher mean fracture load compared to control groups. After chewing simulation, air-abraded groups showed lower mean fracture load compared to control groups. Aging decreased the Weibull modulus of all tested groups, and air-abraded groups showed lower Weibull moduli compared to control groups. © 2012 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater 100B: 1683–1690, 2012.Keywords
This publication has 34 references indexed in Scilit:
- Load-bearing capacity and failure types of anterior zirconia crowns veneered with overpressing and layering techniquesDental Materials, 2011
- Physical properties of current dental nanohybrid and nanofill light-cured resin compositesDental Materials, 2011
- The influence of support properties and complexity on fracture strength and fracture mode of all-ceramic fixed dental prosthesesActa Odontologica Scandinavica, 2011
- Fracture load and failure analysis of zirconia single crowns veneered withpressed and layered ceramics after chewing simulationDental Materials Journal, 2011
- Effect of air-abrasion on the retention of zirconia ceramic crowns luted with different cements before and after artificial agingDental Materials, 2010
- Influence of surface treatments on surface roughness, phase transformation, and biaxial flexural strength of Y‐TZP ceramicsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2009
- Influence of Post and Resin Cement on Stress Distribution of Maxillary Central Incisors Restored with Direct Resin CompositeOperative Dentistry, 2009
- Finite element analysis model to simulate the behavior of luting cements during settingDental Materials, 2005
- Transformation Toughening in Zirconia‐Containing CeramicsJournal of the American Ceramic Society, 2000
- Effects of sandblasting and silica-coating procedures on pure titaniumJournal of Dentistry, 1994