A new calculation procedure for non-uniform residual stress analysis by the hole-drilling method
- 1 January 1998
- journal article
- Published by SAGE Publications in The Journal of Strain Analysis for Engineering Design
- Vol. 33 (1) , 27-37
Abstract
The hole-drilling method is one of the most used semi-destructive techniques for residual stress analysis in mechanical parts. In the presence of non-uniform residual stress, the stress field can be determined from the measured relaxed strains using several calculation methods, but the most used one is the so-called integral method. This method is characterized by some simplifications that lead to approximate results, especially when the residual stress varies abruptly. In this paper a new calculation procedure called the spline methods is proposed, which allows these drawbacks to be overcome. Numerical simulations and an experimental test have corroborated the best performance of the proposed technique with respect to the calculation procedures used at present.Keywords
This publication has 10 references indexed in Scilit:
- Optimization of depth increment distribution in the ring-core methodThe Journal of Strain Analysis for Engineering Design, 1996
- Determination of Nonuniform Residual Stresses Using the Ring-Core MethodJournal of Engineering Materials and Technology, 1996
- Data Management for the Evaluation of Residual Stresses by the Incremental Hole-Drilling MethodJournal of Engineering Materials and Technology, 1994
- Non‐uniform residual stress measurements by the hole drilling methodStrain, 1992
- Measurement of Non-Uniform Residual Stresses Using the Hole-Drilling Method. Part I—Stress Calculation ProceduresJournal of Engineering Materials and Technology, 1988
- Determination of residual-stress variation with depth by the hole-drilling methodExperimental Mechanics, 1985
- Measurement of residual-stress distribution by the incremental hole-drilling methodExperimental Mechanics, 1985
- On the correction of residual stress measurements obtained using the centre‐hole methodStrain, 1982
- Application of Finite Element Calculations to Residual Stress MeasurementsJournal of Engineering Materials and Technology, 1981
- A Practical Guide to Splines1978