A Phase-Leg Power Module Packaged With Optimized Planar Interconnections and Integrated Double-Sided Cooling
- 18 March 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 2 (3) , 443-450
Abstract
A multilayer planar interconnection structure was used for the packaging of liquid-cooled automotive power modules. The power semiconductor switch dies are sandwiched between two symmetric substrates, providing planar electrical interconnections and insulation. Two minicoolers are directly bonded to the outside of these substrates, allowing double-sided, integrated cooling. The power switch dies are orientated in a face-up/face-down 3-D interconnection configuration to form a phase leg. The bonding areas between the dies and substrates, and the substrates and coolers are designed to use identical materials and are formed in one heating process. A special packaging process has been developed so that high-efficiency production can be implemented. Incorporating high-efficiency cooling and low-loss electrical interconnections allows dramatic improvements in systems' cost, and electrical conversion efficiency. These features are demonstrated in a planar bond-packaged prototype of a 200 A/1200 V phase-leg power module made of silicon (Si) insulated gate bipolar transistor and PiN diodes.Keywords
Funding Information
- Advanced Power Electronics and Electric Motors Program
- DOE Vehicle Technologies Office through UT Battelle, LLC (DE-AC05-00OR22725)
This publication has 12 references indexed in Scilit:
- SKiN: Double side sintering technology for new packages2011
- Development of Power Control Unit for Compact-Class VehicleSAE International Journal of Passenger Cars - Electronic and Electrical Systems, 2009
- Power Electronics and Motor Drives in Electric, Hybrid Electric, and Plug-In Hybrid Electric VehiclesIEEE Transactions on Industrial Electronics, 2008
- Prognostic and Warning System for Power-Electronic Modules in Electric, Hybrid Electric, and Fuel-Cell VehiclesIEEE Transactions on Industrial Electronics, 2008
- Three-dimensional packaging for power semiconductor devices and modulesIEEE Transactions on Advanced Packaging, 2005
- Power module integrated cooling design using CFD simulation2002
- An advanced approach to power module packaging2002
- Double-sided cooling for high power IGBT modules using flip chip technologyIEEE Transactions on Components and Packaging Technologies, 2001
- Thermal characterization of a liquid cooled AlSiC base plate with integral pin finsIEEE Transactions on Components and Packaging Technologies, 2001
- Optimized cooling systems for high-power semiconductor devicesIEEE Transactions on Industrial Electronics, 2001