Functionally Graded WC-Reinforced Stainless-Steel Composites via Casting: Microstructure and Wear Performance
Open Access
- 12 September 2025
- journal article
- research article
- Published by MDPI AG in Journal of Composites Science
- Vol. 9 (9) , 495
Abstract
This study presents an effective route for producing functionally graded metal matrix composites with enhanced abrasion wear resistance by incorporating ex situ Fe–WC preforms into austenitic stainless-steel castings. The preforms, produced by cold-pressing mixed WC and Fe powders, were positioned in the desired locations in sand molds and reacted in situ with the molten steel during casting. This process generated a metallurgically bonded reinforcement zone with a continuous microstructural and compositional gradient, characteristic of a Functionally Graded Material (FGM). Near the surface, the microstructure consisted of a martensitic matrix with WC particles and (W,Fe,Cr)6C carbides, while towards the base metal, it transitioned to austenitic dendrites with an interdendritic network of Cr- and W-rich carbides, including (W,Fe,Cr)6C, (Fe,Cr,W)7C3, and (Fe,Cr,W)23C6. Vickers hardness measurements revealed surface-adjacent values (969 ± 72 HV 30) approximately six times higher than those of the base alloy, and micro-abrasion tests demonstrated a 70% reduction in micro-abrasion wear rate in the reinforced zones. These findings show that WC dissolution during casting enables tailored hardness and abrasion wear performance, offering an accessible manufacturing solution for high-demand mechanical environments.Keywords
All Related Versions
Funding Information
- FCT—Fundação para a Ciência e a Tecnologia, I.P. (UIDB/50022/2020)
This publication has 27 references indexed in Scilit:
- Local composite reinforcements of WC/Fe-C type obtained in-situ via SHS synthesis in gray cast iron castingsJournal of Alloys and Compounds, 2025
- An Evaluation of WC-Co Tool Tip Scraps Reinforcement in the Hadfield Austenitic Manganese Steel Fabricated In Situ Steel CastingMetallography, Microstructure, and Analysis, 2023
- Effect of WC Composition on the Microstructure and Surface Properties of Laser Directed Energy Deposited SS 316-WC CompositesJournal of Materials Engineering and Performance, 2021
- In situ synthesis WC reinforced iron surface composite produced by spark plasma sintering and castingMaterials Letters, 2018
- Repair of 304 stainless steel by laser cladding with 316L stainless steel powders followed by laser surface alloying with WC powdersJournal of Manufacturing Processes, 2016
- Friction and Wear2015
- Interface Structure and Wear Behavior of Cr26 Ferrous Matrix Surface Composites Reinforced with CTCPTribology Letters, 2014
- Effect of Ni Addition on Microstructure of Matrix in Casting Tungsten Carbide Particle Reinforced CompositeJournal of Materials Science & Technology, 2013
- Metal Matrix Composites2013
- Structure–property-correlation in laser surface alloyed AISI 304 stainless steel with WC+Ni+NiCrMaterials Science and Engineering: A, 2012