Effective Taper Criterion for the Full Veneer Crown Preparation in Preclinical Prosthodontics
Authors:
- John J. GaryJGJohn J. Gary
- J. Elaine ConkinJCJ. Elaine Conkin
- 1 September 1999
- journal article
- Published by Wiley in Journal of Prosthodontics
- Vol. 8 (3) , 196-200
Abstract
Purpose: Effective taper criteria must define a realistic, measurable goal that the student can visualize and achieve. Six degrees is widely accepted as the taper criterion for the full veneer crown preparation. However, studies show the actual taper of most preparations to be greater than 12°. The purpose of this study was to determine whether 12° is an effective taper criterion for the full veneer crown preparation in preclinical prosthodontics instruction.Materials and Methods: A group of 191 full veneer crown preparations with 6° as the taper criterion, and a group of 130 full veneer crown preparations with 12° as the taper criterion were evaluated. All preparations were accomplished by preclinical dental students working on typodonts under examination conditions.Results: The overall mean taper for each group exceeded the targeted criterion. The overall mean taper for the 6° group was 14.490. When 12° was the criterion, the overall mean taper was 15.580. The t test results indicate significant differences (p < .0001) between the targeted criterion and the actual preparation mean taper in all samples except one: the faciolingual measurements in the 12° group. The faciolingual measurement of 12.920 was not statistically significantly different (.0542) from the targeted criterion of 12°.Conclusion: The use of a 12° taper criterion did not result in preclinical students achieving the goal of a 12° taper. However, a 12° criterion is more realistic than a 6° criterion for full veneer crown preparations.Keywords
This publication has 18 references indexed in Scilit:
- Patient‐Centered Competency‐Based Education in Fixed ProsthodonticsJournal of Prosthodontics, 1996
- Axial wall convergence of full veneer crown preparations Documented for dental students and general practitionersActa Odontologica Scandinavica, 1996
- The Relationship Between Preparation Convergence and Retention of Extracoronal RetainersJournal of Prosthodontics, 1994
- New Guidelines for Preparation TaperJournal of Prosthodontics, 1993
- Quantitative determination of taper adequate to provide resistance form: Concept of limiting taperThe Journal of Prosthetic Dentistry, 1988
- The convergence angle of tooth preparations for complete crownsThe Journal of Prosthetic Dentistry, 1987
- Retention and resistance in preparations for extracoronal restorations. Part II: Practical and clinical studiesThe Journal of Prosthetic Dentistry, 1986
- A theoretical and clinical investigation into the taper achieved on crown and inlay preparationsJournal of Oral Rehabilitation, 1980
- The convergence angle in teeth prepared for artificial crownsJournal of Oral Rehabilitation, 1978
- The Relationship Between Retention and Convergence Angle in Cemented Veneer CrownsActa Odontologica Scandinavica, 1955